These jobs always end up with a few more steps added on. It came out fine when I took the bulb out but when I went to put the new bulb in, it just came apart. That explains why there was condensation in there. Currently sat holding it together while the epoxy sets.
The old o-ring was a bit perished and flat so I've ordered some new ones from eBay that should be here by the weekend. I'll do both sides.
I don't know about anyone else, but I like these kinds of jobs - the ones nobody is going to notice or know about, but it just makes the car better, more together, like when I put rubber grommets behind the lower dash to stop it from creaking, or putting new sticky foam on the hands free mic. The car might be old, but it's properly 'together'.
Sent from my iPhone using Tapatalk