Diffuser not sitting right

Yoshi

Active Member
Mar 8, 2023
78
32
Hi guys,

I've had a rear reiger diffuser fitted but one side seems to be slipping out by 1-2cm ide say. Ok if I push it back on for a few miles but then slips again. The one side fits fine.

Not sure if I should use something to help it stick when pushed back in?

There's 3 screws holding the diffuser between the two exhausts but nothing between the exhaust and outside edge of the car. I know usually there is 1 screw each (between the exhaust and the outside edge of the car), there is on the original diffuser but can't actually see a hole to screw into even if I drilled one into the diffuser.

Any ideas?
1000016221.jpg
1000016220.jpg
 

H Rafiq

Active Member
Jan 5, 2022
1,165
492
Can you take it off and make a hole for the sides and put a screw in each side?
 
  • Like
Reactions: Yoshi

Yoshi

Active Member
Mar 8, 2023
78
32
Can you take it off and make a hole for the sides and put a screw in each side?

Can't see anywhere which the screw would go through to.

I have been recommended tiger seal so ile try that where i've circled on the photo then push on and leave for 24 hours.
 
Genuine SEAT Parts and Accessories.