maf

Hey, Had my car remapped some months back and dispite some surging issues with light throttle in second gear (has a new firge dv fitted) and recently what seems like clutch slip of a slight hesitation at around 3,100rpm in 4th, 5th, 6th (not sure which the cause is) it goes fine. Also only...

As i'm 90% sure my MAF is playing up i need to get it replaced under its VW warranty, problem is they'll only replace it when its completely screwed and throws up a code. That would be fine under normal circumstances, i'd just drive it until it dies but on this occasion i'm reluctant to do that...

Unplugged my MAF 2 days ago due to it causing the odd missfire. Vagcom shows 2 fault codes now. 1. MAF Signal too low (expected as MAF is unplugged) 2. ADDRESS 03: ABS BRAKES 1 FAULT FOUND: 01314 - ENGINE CONTROL MODULE 79-00 - PLEASE CHECK FAULT CODES Is the second code MAF...

had my car vag-com'd a while back as it was loosing power and it showed up to be the maf sensor. after replacing the maf sensor twice with both sensors being genuine seat ones the power loss is still there and the fault code still keeps showing up ive even tried clearing the codes but they...

Had a few missfires the last couple of days only under load while booting it, VAGCOM shows no codes. Coilpacks and plugs seem ok but what i found odd was that unplugging the MAF seems to cure the problem (and makes the car a little faster). So i'm presuming the MAF is screwed (again), could the...

Just wondered if anyone has replaced their MAF with one from a breakers yard. I need a new one but i don't know whether to get a re con from SEAT or a 2nd hand one from a scrappy. Any thoughts?

.

Hi, Just had my car remapped ect.... but a day after driving it it started to have fits! Basically it went into limp mode, then i switched the engine of for a couple of mins then tried it again and it boosted fine but then after 5 mins if i put my foot down the car would start to...

After changing the N75 valve on my car, it's still having problems. This morning it was idling very rough and almost stalled. I disconnected the MAF sensor, and it ran smoothly on the way to work. The thing is, I expected the engine management light to come on but it didn't. Is this normal...

i replaced my maf a few months ago but its gone again according to the guy at star performance my maf should be under a 12 months warranty but unfortunately i cant find the invoice/proof of purchase as of yet do you think the dealers will be ok with it or not i dont really want to shell...

Hello I recently aquired a VERY Large cold air feed pipe to give my K&N induction kit more air to breath! To put it into perspective the pipe supplied was probably about 50mm dia, this pipe is 105mm dia. and of course before i put it on, i must consult trusty ol' SCN! ;) with this increase in...

is this 3" in diametre,:rolleyes: any one got bosh part number and any one know where i can pick up a cheap one quick cheers!!!

va com'd my car and it said maf signal reading low, I ordered a new maf, fitted it and it wouldnt go over 3k RPM... so I sent it back and ordered another from gsf car parts... to my amazement same result! I disconnected the ecu for 15 mins before trying again and it made no difference...

Can anyone tell me if theres a way of testing to see if your MAF is on its way out without vag-com?? If not is there anyone near Halifax with vag-com who could help??:help:

Hi guys once again needing some help/advise!! My LCR ir running stage 2 and has always pulled really well in all gears as i`m sure most do but just had a new Blueflame downpipe fitted as the last one split on the flexi on the return from Germany and now sometimes she pulls as she always has and...

Iv had my car Revo'ed for over a month now and still loving it but noticed something the other day and got me a bit bothered!! When in 6th and start to accelerate the revs quickly go up 500 or so RPM and then it starts accelerating normally revo dude did tell me it might be worth investing in...

Hi I have a 01 cupra about a year ago I got the emmisions light and intemitent loss of power, eventually replaced the maf sensor instantly everything was back to normal. Recently the idle is eratic /low and now the light is back on and starting the power loss again. could it be the maf again...

As subject says, I've been told it's ok to run the engine with this disconnected (I'm trying to determine if the MAF is faulty). If the engine works ok with it disconnected, what's the point of this component?

So much for big turbo solving my MAF problems. :cry: Number 10 must have done less than 1500 miles and I wasn't caning it at the time. ;)

Just thought I'd leave a quick message about the problems I've had with my V5 and what I did to fix it, just in case anybody else has the same frustrating problem as I did For about 3 or 4 months the performance on my car had been deteriorating on an intermittent basis, especially on up...