logs

Running HB2T5, after 5k the N75 duty starts to drop and the boost drops away. Should a K04 not be reequesting more? Engine RPM Air Mass Flow Throttle Opening Ign. Timing Engine Speed Load req psi del psi Engine Speed Intake Temp N75 Duty Cycle Press @ Intercool /min g/s % °...

Could somebody who knows what they are looking at tell me if all is ok with theese logs, e.g intake temp, mass aiflow etc. had the engine light on, maf came up but cleared it and hasnt come back. i keep loosing boost (peaks at 7 no higher instaed of 22) any help would be greatfull. taken in 3rd...

This is the first time i have logged My ibiza cupra, totally standard other than a uprated recirc valve and a remap to 191.8 bhp... Do the mass flow reading give an indication as to the MAF and how it is functioning?? If so does my maf look ok after these logs in 3rd and 4th? And...

hello guys!:) I would like to ask you something.. I 'm looking an ignition timing(block 020) logs from a STOCK Leon cupra 180hp.. without ecu remap,without exhaust. Nothing,notaly stock... Does anyone have one?....Please help me:) Is really hard to find here in greece a stock leon...

Hi Guys, I've just been out and done my first proper logging as I think something isn't quite right with my car. (Remapped LC with induction kit). I'm getting this error frequently: 17705 - Pressure Drop between Turbo and Throttle Valve (check D.V.!) P1297 - 35-00 - -...

These are my logs, ne1 help??? what needs replacing ETC... Logs 003: RPM Mass Flow Load Ign. Timing TIME STAMP /min g/s % ° 0.02 1760 8.61 7.1 28.5 1.27 1760 8.72 7.1 28.5 2.68 1760 8.67 7.1 28.5 3.98 1840 22.39 96.1 16.5 5.38 2000 29.06 100 8.3 6.77 2240 36.64 100 8.3...

Hey guys i managed to get my laguna intercooler fitted this weekend have got pics up yet but will get some later, i did a logging seseion last night after i got it fitted just though id show every one see what they think of it, it was hot last nigth though car said was 16oc but heres what i...

Well not me personally but a friend who doesn't have access to the Internet at the moment. Car is a Hybrid K04 1.8T which has not been running right as of late. The car appears to be running very conservative boost as it should be boosting 28psi and sustaining 20psi at 7k. We had...

I have done some boost logs recently for my remapped cupra. For those experts out there should actual boost always be above spec. My actual is above spec up till 3K where it starts to fall below spec. Thanks 4th gear cc ph1 Mark RPM spec Act d.cycle 0.38 1554 1068 1140 31.5 0.78...

Just did these earlier on. What do you guys and gals reckon. Thanks Block 11 4th gear Custom code pH1 and Milltek Mark RPM Spec Actual Duty Cycle 3.74 1554 2052 1644 35.9 4.14 1617 2184 1872 40.2 4.54 1701 2304 2124 51.4 4.94 1785 2424 2376 55 5.34 1890 2508 2556 58.6 5.74...

Hey, Did some 3rd gear logs last night, 7ºC outside.... T9 HB6... Suggestions/comments/opinions welcome... Group A: '118 Group B: '115 RPM Temperature Load Absolute Pres. RPM Load Absolute Pres. Absolute Pres. TIME TIME STAMP /min °C % mbar STAMP /min % mbar...

Here is a log (115) from a mapped Cupra R. This isn't my car and I drive a Leon Cupra, I am not sure what the boost levels are suppose to be at. Does it look ok? Group A: '115 RPM Load Absolute Pres. Absolute Pres. /min % mbar mbar 2520 118.8 1990 1570 2680 123.3 1960 1630...

Revo Stage 2. Std Paper Filter in airbox (with cold feed) T7 HB8 Air temp 8.5 degrees Group A: '003 Group B: '020 Idle speed Air mass in Throt Angle Ignit Angle Idle Stabilization Idle Stabilization Idle Stabilization Idle Stabilization 700-820 rpm 2.0-4.5 g/s 0.2-4.0% 0-12 BTDC...

Logs for 002, is anything wrong? (BTW i have bugger all knowledge of VAG Com, so please be gentle!) Saturday30December200609:25:02 TIME RPMLoadInj. On TimeMass Flow STAMP /min% ms g/s 0.00 3040 106.8 13.94 67.28 0.60 3120 139.8 18.86 89.31 1.20 3240 160.9 21.73 98.42 1.78...

Here are some logs of my Hybrid K04 turbo. According to the car the outside temp was around 11.5 degrees. The turbo is running revo stage two and on High Boost 3 and Timing 6. I have been running it on these settings to run the turbo in basicly. The car was run at 9 and 9 when it was fitted to...

So, After reading Rob thread about the VAGCom logs on his car, I just went out and did some logs on mine. I think they look ok but I wonder if someone can confirm that everything is happy! :) Group A: '003 RPM Mass Flow Load Ign. Timing TIME Marker STAMP /min g/s % °BTDC...

vag com'd peters car today as it went into limp mode the other day, no fault codes came up and i did a log of actual v requested and a maf i can spot any problems but its different map to mine and different turbo! there was a big drop off in boost after 5k but was spot on through midrange...

Hello all, ive done a few runs and wondered what you all think. Group A: '003 Group B: '004 Group C: '020 RPM Mass Flow Load Ign. Timing RPM Voltage Temperature Temperature Idle Stabilization Idle Stabilization Idle Stabilization Idle Stabilization TIME TIME TIME...

Ok, Finally got a full licence for vag-com and took 2 logs, one at idle one at driving (got stuck in traffic on dual carriageway tho) First log shows mainly about the cat sensor voltage. I noticed it wasnt anywhere near the parameters shown (below 1v) and the other log just shows important...

I've seen plenty of logs of revo'd LCR's pushing 190-200 g/s on stage 1 but I'm running APR stage 1 and I've never got over 190 g/s. Is this normal due to APR running less boost or is my MAF under reading? How do other APR'd cars fair compared to Revo etc..when it comes to air flow. Don't...