what did you and your mk3 leon do today

[Eggy]

Fitted an LED for the reverse light today

What LED did you use? How's the difference in the dark compared to original bulb?

 

[niallain]

What LED did you use? How's the difference in the dark compared to original bulb?

https://www.ebay.co.uk/itm/P21W-382...var=591055800017&_trksid=p2057872.m2749.l2649


Haven't had a chance to test it in the dark yet, but by judging how much brighter it is during the daytime it should be A LOT better.

 

[Eggy]

Should try this too...I have quite dark tint on the rear end and it is quite hard to see Actually i am searching for some extra lights to use, it would be nice to have some LED strip lights instead of the rear lower bumper red reflector strips.

 

[Lentäjä]

I called recovery truck to take it to the dealer.

When cruising at 100kmh, engine light flashed, EPC light popped on, engine start to run on 2 or 3 cylinders...
So i pulled over, stop the motor, did a quick scan on fault memory...
P0136 O2 Sensor Circuit Bank1 Sensor 2
P2237 O2 Sensor Positive Current Control Circuit/Open Bank1 Sensor 1
P0301 Cylinder 1 Missfire detected
P0304 Cylinder 4 Missfire detected
P0300 Random/Multiple Cylinder Missfire detected

Tried to start the car...nope...its spinning but does not fire up.

 

[CupraNJ]

Fitted four of these:

Not today, but two weeks ago. It's been damp and wet, but impressed with grip levels so far. Admittedly I'm comparing them to 2 year old Potenza's, which although had a bit of tread left were hopeless. Better curbing protection too.

Fixed now.

 

[CupraNJ]

Fitted four of these:

Not today, but two weeks ago. It's been damp and wet, but impressed with grip levels so far. Admittedly I'm comparing them to 2 year old Potenza's, which although had a bit of tread left were hopeless. Better curbing protection too.

For some reason the image file linky thing didn't work. Dont know why, any clues? The image showed on of my shiny new PS4S tyres.

 

[niallain]

For some reason the image file linky thing didn't work. Dont know why, any clues? The image showed on of my shiny new PS4S tyres.

Need to link the image directly if you're putting in the IMG tags

 

[CupraNJ]

Need to link the image directly if you're putting in the IMG tags

Much obliged.

 

[robby71]

Fitted mist washer jets (Thanks Dan) today

Also finished fitting piano black climate front panel to match the piano black air and info surround i fitted last week

Fitted MK7 Golf GTi genuine pedals a couple of weeks ago (bought cheap chinese ones which were crap so threw them away) and today fitted a matching Golf GTi foorest

Bought a set of Cupra 18" alloys with Goodyear Eagle F1s which need a refurb to be perfect, not sure if i should fit them as is for winter?

 

[g_berserk]

Finally bought a new set of wiper blades in a VW dealer since they were three times more expensive at SEAT for some reason
Had to settle with 24/16 tho since VW doesn't have any car with 26" blades, but it's ok.

Also took the car for a quick wash for the first time in almost a month

 

[niallain]

Fitted MK7 Golf GTi genuine pedals a couple of weeks ago (bought cheap chinese ones which were crap so threw them away) and today fitted a matching Golf GTi foorest

How much did the pedals and footrest cost? Got a link to where you bought them from?

 

[p.eco]

How much did the pedals and footrest cost? Got a link to where you bought them from?

I have Chinese pedal set but cannot complain, very good made and a cannot see the difference in OEMS. Have them nearly 3 years now, no issues...

Sent from my Nexus 6P using Tapatalk

 

[R4CK5]

]

Essentially here is the steps to take depending on which year of car you have:
- Carbon Navi screen (for cars up to MY2015) Leon 5F,
Information Electrics,
Coding 70
Byte 17
Bit 0 false
Bit 1 true
Reboot the Radio (hold on/off button for 10 seconds)

- For cars from MY2016 or Navi plus, Leon 5F:
Information Electrics,
Coding 07
Byte 17
Bit 0 true
Bit 1 true
Radio reboot (hold on/off button for 10 seconds)

After doing this, my resolution decreased and all icons where big?[/QUOTE]Same with mine my17. I think I reactivated bit 1 and bit 2 was for the carbon screen. On the guide I used it said bit 3 or something and that didn't work so I activated the third bit in the list just as a stab in the dark and by some miracle it worked.

Sent from my SM-G950F using Tapatalk

 

[Kinetic]

Finally bought a new set of wiper blades in a VW dealer since they were three times more expensive at SEAT for some reason
Had to settle with 24/16 tho since VW doesn't have any car with 26" blades, but it's ok.

Also took the car for a quick wash for the first time in almost a month

Search for HEYNER Aeroflat Windscreen Wiper Blades 26"16" on Amazon, they were recommended somewhere on here.

 

[zeffania]

worked out why my passenger door vibrates from certain bass frequencies. Pull the handle and it stops. I shall be purchasing some clips and a foam rectangle and shall be gluing that to the door card for vibration free music

 

[bega]

worked out why my passenger door vibrates from certain bass frequencies. Pull the handle and it stops. I shall be purchasing some clips and a foam rectangle and shall be gluing that to the door card for vibration free music

My brother said always if you hear some noises in car,then music isnt that loud you should turn it up louder
I hate my self for kinda like this,everyhing needs to be perfect,I mean it cant but almost near perfect,but for him,he just dont give a crap about it

Sent from my G8441 using Tapatalk

 

[zeffania]

My brother said always if you hear some noises in car,then music isnt that loud you should turn it up louder
I hate my self for kinda like this,everyhing needs to be perfect,I mean it cant but almost near perfect,but for him,he just dont give a crap about it

Sent from my G8441 using Tapatalk

Ah, but that doesn't work when it is the certain frequency in the bass making it make that noise. Was Massive Attack this morning and thankfully I was stopped at lights so pushed and pulled the door. 95% it is fine, just that one frequency that the door doesn't like. Just a bit of foam to push the door away should sort it. Already asked the wife to grab me some clips from work as I am sure I will break one.

Just need to source some foam now. Edit - found some. Cisco switch packing, thanks very much

 

[bega]

Ah, but that doesn't work when it is the certain frequency in the bass making it make that noise. Was Massive Attack this morning and thankfully I was stopped at lights so pushed and pulled the door. 95% it is fine, just that one frequency that the door doesn't like. Just a bit of foam to push the door away should sort it. Already asked the wife to grab me some clips from work as I am sure I will break one.

Just need to source some foam now. Edit - found some. Cisco switch packing, thanks very much

Hope you will sort it out good luck and enjoy the music

Sent from my G8441 using Tapatalk

 

[zeffania]

Hope you will sort it out good luck and enjoy the music

Sent from my G8441 using Tapatalk

Cheers bud, just glad I know it isn't the speaker

 

[Deleted member 103408]

Fitted new Inlet Manifold Cover