• Guest would you be interested in CUPRA or SEAT valve caps? let us know in the poll

  • Welcome to our new sponsor Lecatona, a brand dedicated to enhancing performance for VAG group sports cars, including SEAT, Audi, Volkswagen and Škoda. Specializing in High Pressure Fuel Pump (HPFP) upgrades.

what have you done to your car today ?

Israar

Active Member
Dec 8, 2014
450
4
Dudley
Had my turbo replaced with a brand new one last Thursday, been without internet for a while thus not being on here! :O

--Lee
 

rossi46

Active Member
Jan 1, 2011
495
0
Kent
Fitted new climate control unit, ran hose through the bulkhead for my boost gauge and sealed all up! (hopefully) fit gauges and pillar pod tomorrow!


Hi mate just wondered what gauges and pillar pods you have to instal and pics? I'm looking at getting a nomad single pillar pod and 52mm r spec stepper motor psi boost gauge. Would be good to get your opinion of yours.


Sent from my iPhone using Tapatalk
 

marcus.l

Active Member
Dec 31, 2011
168
0
Manchester
My Lc's been running like a bag of shite the past couple of days, lumpy idle cutting out the works so today I changed the maf and got some new Bosch 2.0 tfsi coilpacks and adapters, fitted em and took it for a run. The idles now smooth ,but still cut out at two sets of traffic lights[:@] so next it'll be to clean the throttle body and sensor and see if that cures that.
 

Welsh

Active Member
d3d51e23f312c9ffb9ff883d2ec1201b.jpg
this but now it's smoking.... Petrol btw


Sent from my iPhone using Tapatalk
 

Aaron87

Active Member
Nov 19, 2013
272
0
Stripped the interior fully, ordered solid engine mounts, bucket seat subframes, new steering wheel and snap off boss!! Buying a roll cage later too!
a8a297d9eff6bc9737f4ac5831159870.jpg



Sent from my iPhone using Tapatalk
 

Stokiekris

Active Member
Dec 24, 2014
53
0
Took the **** universal cone filter off and re fitted the standard (drilled) air box and filter :) but just remembered I forgot to re attach the sai pipe doh! Lol
 

MOROalTT

Active Member
Mar 19, 2011
180
0
USA
Did some cooking.

75a0e52e13f6a470aa51432cce512470.jpg

58f190e3716f629fedd0c4db9a1f3177.jpg

bf695dafd65522fd471a9a6d74024894.jpg



Dunno why it turned out so dark.... Little disappointed... But better then it was !


[url=https://flic.kr/p/r1htMa] WhanAB spacer & shield by whanabiv, on Flickr[/URL]

[url=https://flic.kr/p/rhGXa8] WhanAB spacer & shield by whanabiv, on Flickr[/URL]

[url=https://flic.kr/p/rfpMuo] WhanAB spacer & shield by whanabiv, on Flickr[/URL]

[url=https://flic.kr/p/rhyVeB] WhanAB spacer & shield by whanabiv, on Flickr[/URL]

there is a 3/16 inch spacer between valve cover and the polished/mirrored aluminium shield and the wires are also protected by Heat Shield high heat wrap has a open air flow from right to left.............

We also used Heat Shield high heat wrap on the Timing Chain Cover as it was getting some much heat from the upgraded turbo it was melting... Just an FYI on that.......

We are going to start selling the spacer kit for the valve cover.... What do you think of it ?????


it is held down with the existing bolt for the ground
 

gbshahaq

Active Member
Sep 26, 2014
12
0
bought some new boots for the front. Yokohamas - so at least they'll be matching front to back
 

rossi46

Active Member
Jan 1, 2011
495
0
Kent
Set up for a big day. Front and rear Eibach arb kit, full service, inlet manifold power gasket, injector o rings and gearbox shim kit. Will be a busy one!


Stage 2 mk1 LCR 291bhp AmD tuned.
 
SEATCUPRA.NET Forum merchandise