i fitted LCR alloys to my TDI Cupra and painted the calipers red:
a massive improvement
Looks sweet. I'm guessing you removed the calipers to paint them ?
-
Welcome to our new sponsor Lecatona, a brand dedicated to enhancing performance for VAG group sports cars, including SEAT, Audi, Volkswagen and Škoda. Specializing in High Pressure Fuel Pump (HPFP) upgrades.
-
The forums will be offline for maintenance on Friday 15th November at 10pm for up to an hour. Thank you for your patience.
what have you done to your car today ?
- Thread starter seatcupramad23
- Start date
Looks sweet. I'm guessing you removed the calipers to paint them ?
wrapped my spoiler in Monsterwraps exclusive MW4D carbon fibre vinyl, this stuff is the dogs dangleys! I'm never going back to the crappy 3M stuff
Tinted my fogs yellow on saturday and took a picture today lol
yellow fogs are the best! im tempted to get yellow 3000k HIDs for mine
i wont lie mate, it was the front end picture of your car that made my mind up about getting them lol
there always on now, well at least untill i gets pulled over by old bill!
there always on now, well at least untill i gets pulled over by old bill!
haha i know what you mean mine are always on ive never been pulled. ive got leds in them bu they aren't that bright so i think they let me off haha
Loving that front end! Where did you get your LEDs from
What bulbs and where from?
Received my 1.8t pancake pipe and jubilee clips, just waiting on my 50mm silicone hose now to attach to the PD150 red turbo pipe!
Also did a power run earlier, 4th gear slightly up hill and had 155.6g/s air flow at around 4,400rpm which equates to 194.5bhp??? My car isn't mapped as far as I know though...does this sound right or will it be the extra grunt required for the slight incline?
Also did a power run earlier, 4th gear slightly up hill and had 155.6g/s air flow at around 4,400rpm which equates to 194.5bhp??? My car isn't mapped as far as I know though...does this sound right or will it be the extra grunt required for the slight incline?
I bought them here: http://dx.com/p/6w-98lm-6000k-6-led-white-light-car-daytime-running-light-lamp-12v-pair-135990
$10 inc shipment. You have to seal them with kit or something to make them weatherproof.
They look so good and only £6
Sent from my iPhone
They are complete units (inc projectors) and have CCFL rings in them. Way brighter than standard led ones
http://www.ebay.co.uk/itm/380529569152
2 more pics then
JDEngineering_NDPHOTO_20130615_014 by ND-Photo.nl, on Flickr
JDEngineering_NDPHOTO_20130615_015 by ND-Photo.nl, on Flickr
Last edited:
They are complete units (inc projectors) and have CCFL rings in them. Way brighter than standard led ones
http://www.ebay.co.uk/itm/380529569152
2 more pics then
JDEngineering_NDPHOTO_20130615_014 by ND-Photo.nl, on Flickr
JDEngineering_NDPHOTO_20130615_015 by ND-Photo.nl, on Flickr
gits should have patented it lol
Hey mate, I have the PD150 Cupra TDI so should have around 150 as standard. Have heard some of these cars have 160-170 from standard but never 194bhp?
Current mods engine wise are:
Cold air feed to original airbox
Cleaned out inlet manifold
Cleaned out and blocked off EGR (not deleted yet)
Catch can
New lower and upper pipes from I/C to EGR
Is g/s an accurate measure of bhp (when using the x0.8 conversion)?
Also I'm getting around 1.5bar boost (21psi), is this standard for the PD150?
Similar threads
