I never intended on doing a readers' ride, it all seemed far too much hard work! But since I've put a few threads up on here of some substantial mods to my car, a moderator collated some of my progress and thus my readers ride is born..
Bare with me as this post I had to edit, and it merges with 'coilover fitting' post in one big mess
So here goes..
I bought my LCR back in January this year. I was getting by with a Y reg 206 1.4 but I did have an LCR about a year before that so returning to another LCR was an easy lure!
Pic of when I viewed it (yes it was snowing on the day of the test drive, not ideal!)
And that was that, they offered me a good part ex on the 206 and the Leon would be mine in a week..
My LCR has had a full service history and been serviced at the right intervals and I intend on taking the car to it's tuning potential now on standard turbo.. She's covered 50k so cambelt & waterpump won't be too far off as she's 5 years old aswell.
Another once she was home
My plan with the car is to get to stage 2 and improve the car in all of the right areas with top level quality upgrades. I'm not one for wanting 'bigger bhp than yours' but I am aiming around the 280 mark with as close to 290 lb/ft torque once she is mapped to stage 2.
The car did have a Pipercross panel filter for a while, but if you see my recent updates, I'm now running a Jetex open cone.
Instead of going through the small mods that I did early on with the car and didn't post up on here, I'm going to put a spec list of the car as it is now. The car was completely standard when I bought it, not even the fabia wiper had been done, lol.
Engine/Power mods:
-AmD Stage 2 remap
-Milltek 3" downpipe & Decat
-Piper cat back
-42 Draft decat spacer
-Airtec FMIC
-Forge 008 DV - yellow spring
-Forge upper boost hoses
-Forge N75 to charge pipe hoses (ancillary)
-Forge breather hoses (under inlet mani)
-Forge Strut Top Caps
-SFS 3" Turbo intake pipe (TIP)
-Pipercross C0187 air filter
-Jabbasport heatshield
-N249 bypass
-NGK Iridium plugs - cold rating 7
-Porsche 997 Oil and Coolant caps
-Polished charge pipe
-Polished inlet manifold
-Polished dipstick handle
-Newsouth smallport inlet manifold insulating power gasket
-Fuchs Titan Race Pro S engine oil
-V-Power fuel only
-Bonnet sound proofing removed
Chassis/Handling/Transmission:
-Awesome GTI heavy duty SMF clutch kit
-Wavetrac limited slip differential (LSD)
-Forge short shifter
-42 draft VW gear linkage bushes
-AP coilovers
-Neuspeed front ARB
-Eibach rear ARB
-Audi S3 upper front strut brace
-Hughes Engineering rear strut brace
-FULL Superpro polybushed underneath
-EBC Ultimax turbo grooved front discs
-Ferodo DS2500 pads
-Motul RBF660 fluid
-Vredestein Ultrac Sessanta tyres
-Speedline Turini alloys in anthracite
Interior:
-Recaro LCR front seats, oem rears
-Autogauge stepper motion boost/oil gauges with double pillar pod
-Sony iPod head unit with fascia adapter. iPod 80GB classic in glovebox
-Awesome GTI 'Cupra R' mats
-LED interior boot bulb
Exterior:
-Fabia rear wiper conversion
-Full front VW Golf Mk4 Aero wiper arm & blade conversion
-3/4 numberplate
-LED numberplate bulbs
-Phillips Silvervision indicator bulbs all round
-6000K HID kit (H7R bulbs)
-LED sidelights
-Fogs removed
-Fiesta Mk6 tinted side repeaters
-L E O N debadged
Religous use of Shell V-Power since ownership to my wallets disgust! I had a fair size stone chip on my windscreen repaired for free as one of my neighbours is an Autoglass guy. Sorted.
So this is where the post merges up with my coilover treatment on the car..
..Coilovers fitted! And boy I love them. Perfect height, but I've been told alot of the bushes have seen better days so these will need replacing and I'll go for the full Superpro kit at AMD when money/time allows. I think I've seen a TDI Cupra on here that had it done? Jonjay? Someone confirm please...
I'm looking forward to getting the car back to being tight and better than it was from SEAT one day with uprated bushes all round. I'll probably wait till I get the ARBs to get the bush kit done.
Very happy with the coilovers overall, the price and super service I received from the AMD lads, keeping me updated while I shopped in Lakeside
I spoke to Ben before fitting, and we decided for my use it would be best to set them up at a compromised level for fast road use while not being trackday harsh. To me the ride is the same over bumps etc, but the car just feels tighter and more like a go-kart! Sharper turn in etc is all there I noticed on the way home.
Here's a couple of pic's below.......... Not great one's but I will get more don't worry.
Post getting messy again.. Another thread merged sorry..!
Next issue ironed out - the ESP light was stuck on since the last time the boost hose blew off on the motorway. AMD guys had the answer, take MAF off, clear the fault and put MAF back on. ESP light cleared!
Tom
Bare with me as this post I had to edit, and it merges with 'coilover fitting' post in one big mess
So here goes..
I bought my LCR back in January this year. I was getting by with a Y reg 206 1.4 but I did have an LCR about a year before that so returning to another LCR was an easy lure!
Pic of when I viewed it (yes it was snowing on the day of the test drive, not ideal!)
And that was that, they offered me a good part ex on the 206 and the Leon would be mine in a week..
My LCR has had a full service history and been serviced at the right intervals and I intend on taking the car to it's tuning potential now on standard turbo.. She's covered 50k so cambelt & waterpump won't be too far off as she's 5 years old aswell.
Another once she was home
My plan with the car is to get to stage 2 and improve the car in all of the right areas with top level quality upgrades. I'm not one for wanting 'bigger bhp than yours' but I am aiming around the 280 mark with as close to 290 lb/ft torque once she is mapped to stage 2.
The car did have a Pipercross panel filter for a while, but if you see my recent updates, I'm now running a Jetex open cone.
Instead of going through the small mods that I did early on with the car and didn't post up on here, I'm going to put a spec list of the car as it is now. The car was completely standard when I bought it, not even the fabia wiper had been done, lol.
Engine/Power mods:
-AmD Stage 2 remap
-Milltek 3" downpipe & Decat
-Piper cat back
-42 Draft decat spacer
-Airtec FMIC
-Forge 008 DV - yellow spring
-Forge upper boost hoses
-Forge N75 to charge pipe hoses (ancillary)
-Forge breather hoses (under inlet mani)
-Forge Strut Top Caps
-SFS 3" Turbo intake pipe (TIP)
-Pipercross C0187 air filter
-Jabbasport heatshield
-N249 bypass
-NGK Iridium plugs - cold rating 7
-Porsche 997 Oil and Coolant caps
-Polished charge pipe
-Polished inlet manifold
-Polished dipstick handle
-Newsouth smallport inlet manifold insulating power gasket
-Fuchs Titan Race Pro S engine oil
-V-Power fuel only
-Bonnet sound proofing removed
Chassis/Handling/Transmission:
-Awesome GTI heavy duty SMF clutch kit
-Wavetrac limited slip differential (LSD)
-Forge short shifter
-42 draft VW gear linkage bushes
-AP coilovers
-Neuspeed front ARB
-Eibach rear ARB
-Audi S3 upper front strut brace
-Hughes Engineering rear strut brace
-FULL Superpro polybushed underneath
-EBC Ultimax turbo grooved front discs
-Ferodo DS2500 pads
-Motul RBF660 fluid
-Vredestein Ultrac Sessanta tyres
-Speedline Turini alloys in anthracite
Interior:
-Recaro LCR front seats, oem rears
-Autogauge stepper motion boost/oil gauges with double pillar pod
-Sony iPod head unit with fascia adapter. iPod 80GB classic in glovebox
-Awesome GTI 'Cupra R' mats
-LED interior boot bulb
Exterior:
-Fabia rear wiper conversion
-Full front VW Golf Mk4 Aero wiper arm & blade conversion
-3/4 numberplate
-LED numberplate bulbs
-Phillips Silvervision indicator bulbs all round
-6000K HID kit (H7R bulbs)
-LED sidelights
-Fogs removed
-Fiesta Mk6 tinted side repeaters
-L E O N debadged
Religous use of Shell V-Power since ownership to my wallets disgust! I had a fair size stone chip on my windscreen repaired for free as one of my neighbours is an Autoglass guy. Sorted.
So this is where the post merges up with my coilover treatment on the car..
..Coilovers fitted! And boy I love them. Perfect height, but I've been told alot of the bushes have seen better days so these will need replacing and I'll go for the full Superpro kit at AMD when money/time allows. I think I've seen a TDI Cupra on here that had it done? Jonjay? Someone confirm please...
I'm looking forward to getting the car back to being tight and better than it was from SEAT one day with uprated bushes all round. I'll probably wait till I get the ARBs to get the bush kit done.
Very happy with the coilovers overall, the price and super service I received from the AMD lads, keeping me updated while I shopped in Lakeside
I spoke to Ben before fitting, and we decided for my use it would be best to set them up at a compromised level for fast road use while not being trackday harsh. To me the ride is the same over bumps etc, but the car just feels tighter and more like a go-kart! Sharper turn in etc is all there I noticed on the way home.
Here's a couple of pic's below.......... Not great one's but I will get more don't worry.
Post getting messy again.. Another thread merged sorry..!
Next issue ironed out - the ESP light was stuck on since the last time the boost hose blew off on the motorway. AMD guys had the answer, take MAF off, clear the fault and put MAF back on. ESP light cleared!
Tom
Last edited:
![[B)]](/forums/styles/seatcupra/oldforumsmileys/shades.gif "Cool [B)]")
