engine wont start fault code 01314

[philsip]

change the fuel pump relay! chances are if its turnign over, making a spark, and not fuel purging when you turn the ignition on, its the relay most likely!

good luck mate

 

[Cupra20]

Tried that, swapped it with mine and it works

 

[cupraajy]

Starter Motor??

 

[p34ch3y]

not that mate as it turns over

 

[cupraajy]

not that mate as it turns over

right-o just mentioned it cause i did the exact same thing in one of my previous cars and it turned out to be the starter motor......bumped started fine

 

[s1l3nc3r]

Have you tried swaping out the ecu from your mates car yet...???

shouldnt be too much hopefully from a scrappy if you need a new one...

 

[p34ch3y]

Have you tried swaping out the ecu from your mates car yet...???

shouldnt be too much hopefully from a scrappy if you need a new one...

no mate as ive read its not that simple as you need to code them

 

[s1l3nc3r]

You can code them using vag-com not sure how ive never done it but it is possible...

there proberly a guide on here some where maybe in the vag-com section...

 

[__B3NNY__]

Very simple, alot eaiser than some people make out.

Install the new ECU in the car
[Select]

[17 - Instruments]

[Adaptation - 10]
Leave channel at "00"

[Read]

[Save]


[Done, Go Back]

[Close Controller, Go Back - 06]

[Exit]


Turn ignition OFF for 15 seconds. Start vehicle.

 

[p34ch3y]

wish i had the full vag com i realy do

 

[tom w]

is there a crash sensor on these cars? Just a thought .pugs have them that stop the engine running/starting.

 

[RichN]

No inertia switch.

Mr Peach really needs to swap ECU with a mate or get a compatible spare off eBay as a good fault finding measure, but only after checking power and relevant relays as above.