DaNnY_LaD's IHI'd Cupra ( End Of a Eara 08/11/2009)

[PhilW]

Whos mapping it, because you need to ask them what they want really.

550's @ 3bar seem to be about the norm now.

 

[DaNnY_LaD]

Haven't got that far yet Phil....

so 550cc or 480ccs at 3 bar?

 

[DaNnY_LaD]

Just hope the job will be better than your bump strips. lol.

Hahaha i know i know lol

Awesomeness ....

BT is now back on

 

[Damoegan]

BT is now back on

lol make your mind up, Danny...

 

[pj1985]

I had 414cc @ 3bar in mine. 480cc would be good although 550cc give more room but are more £s.

 

[DaNnY_LaD]

Ta Pj :d

ive Desided to go for the JS manifold as the tigart one is crap and im not fully sure about the new Jbs one...

Seems a fair few people are running the Js manifold without problems...

 

[ian_cupra]

i give up

 

[DaNnY_LaD]

seems I have enough to start this now...

Piccys to follow of the bits that ive received today

 

[jamiebennett81]

I wont believe anything until I actually see the physical turbo fitted, mapped and sorted

 

[DaNnY_LaD]

So Piccys of the Td05-16g, Js manifold & 440cc injectors woundnt convise you Anton...

 

[jamiebennett81]

So Piccys of the Td05-16g, Js manifold & 440cc injectors woundnt convise you Anton...

nope

get it fitted and finished then I will

 

[ChrisCurzon]

nope

get it fitted and finished then I will

I wont believe anything until I actually see the physical turbo fitted, mapped and sorted

I'll see if fitted but mapped properly hmmmm
When Danny decides he will get the car mapped properly and not try to 'tweak' it himself i'll

Anyways Daniel stop changing your mind, your worse than a woman clothes shopping........but then again you are a bit of a tart

 

[tarzan]

twin turbo next week

 

[__B3NNY__]

You got to be fcuking joking

 

[DaNnY_LaD]

How much is it to say Cermaic coat a manifold?

 

[h17och]

id say they would charge £100 for one of them

 

[pj1985]

Js mani is internally coated i think. Not sure about external coating on a log mani tbh. Bill might be more helpful.

 

[DaNnY_LaD]

My engine is a AQX 2000reg what Wrist pinis it?

19mm or 20mm

as ive found these
http://cgi.ebay.co.uk/Integrated-En...3|66:2|65:12|39:1|240:1318|301:1|293:1|294:50

 

[DaNnY_LaD]

ignore that Just found out that my use 20mm wrist pins...

also ive desided to go with the IHI Vf22 Slight slower spooling due the P20 housing but alot more topend...

 

[DaNnY_LaD]

Righto..

Ive bought some Bits tonight and took Delievery off my turbo this morning...

Bits Ive bought:
IHI VF23 with Large P20 Exhaust Housing
Walbro 225lph Inline Fuel Pump
Intergrated Engineering Connecting Rods (20mm Wrist pins)
Tig-art Tubular Manifold
Braid Oil Lines