ChrisCurzon

4WD FTW
Apr 9, 2006
1,821
0
Bolton
I had to take off all the original electrical tape, and separate out all the wires. From the ones I could separate out, I ran underneath the manifold, and the others I have just done back up with some electrical tape and cable tied them up against a thin hard pipe which runs discretely along the manifold

was a bit of a pain to do, but looks a lot neater now. Still some work to do on it, but looks better for now

Well the inlets coming off in the new year when i swap it over to the polished one so i might give it ago then, cheers mate
 

NumberoftheBeast

Full Member
Apr 20, 2005
231
0
Manchester
What's wrong with the standard mirrors?

n892605704_837294_2506.jpg


On a serious note, looking good mate!
 

45_CB

Back in the Cupra again
Oct 8, 2007
219
0
Plymouth, Devon
I really like it man, good update.

I have a drivers side stubby mirror sat in my garage and been there about a month or two. Its manual as german ebay people sent me wrong one :( and they wont reply to me
 

ChrisCurzon

4WD FTW
Apr 9, 2006
1,821
0
Bolton
I really like it man, good update.

I have a drivers side stubby mirror sat in my garage and been there about a month or two. Its manual as german ebay people sent me wrong one :( and they wont reply to me

Cheers mate

Thats not good, took me a while to get a reply on postage charges from them as well!
 

ChrisCurzon

4WD FTW
Apr 9, 2006
1,821
0
Bolton
Gave the car a clean today and took some pictures, this is how the car is finishing under my ownership, decided to move on, so the car is now offically for sale!

Let me know what you think

Chris


18122008429.jpg


18122008430.jpg


18122008428.jpg


18122008427.jpg


09122008424.jpg
 
Last edited:

stani540

Active Member
Jan 21, 2007
349
0
Also starting to tidy up the engine bay a little, so sprayed my rocker cover, cam cover and a few brackets black

16112008392.jpg


Decided to spray my power steering cap black too, as it always stood out being green, did look a bit odd

16112008393.jpg

What did you use to sapray the rocker cover mate??

and when you did the power sterrin cap did you just leave it off, or did you cover it with something?
 

ChrisCurzon

4WD FTW
Apr 9, 2006
1,821
0
Bolton
What did you use to sapray the rocker cover mate??

and when you did the power sterrin cap did you just leave it off, or did you cover it with something?

I just used some hammerite, had some lying around so did a few coats with that, it dried really glossy and smooth.
Just took the cap off and put a bit of masking tape over it so nothing went into it, i did the rocker cover at the same time so the car was off the road for a couple of days anyways
 
Adrian Flux insurance services - discount for forum members.