• Guest would you be interested in CUPRA or SEAT valve caps? let us know in the poll

  • Welcome to our new sponsor Lecatona, a brand dedicated to enhancing performance for VAG group sports cars, including SEAT, Audi, Volkswagen and Škoda. Specializing in High Pressure Fuel Pump (HPFP) upgrades.

RS6 8 pot calipers onto an Audi A3 2.0 TDI quattro ?

m0rk

sarcasm comes free
Staff member
May 19, 2001
27,787
33
Clanfield, UK
probably would if you can design your own mounting brackets to fit

and obtain discs in the right offset.

I would look at something more off the shelf, unless you know how to make/design stuff
 
Aug 1, 2005
2,695
0
Cullompton . Devon
I cannot be assed if i got to make custom mounting brackets etc. I was hoping that they would be a direct fit.:( What about the AP calipers from my ibiza cupra would they be a direct fit or would i have to get mounting brackets made ? How hard would it be to get mounting brackets made for the AP calipers to fit the Audi since it would save me alot of money if i could get them to fit and then just buy another set of discs to fit the Audi then buy a whole new setup.
 

Feel

Veedubya 'velle
Jun 12, 2003
4,918
2
Midlands
Bill will know the answer to that as he's sold a few sets IIRC. He's a bit AWOL at the mo', probably getting the car ready for the new season...

Brembos would be a fairly obvious choice though...
 

Yumann

Full Member
May 17, 2002
1,638
0
Glasgow
The RS6 calipers are a no go as they are trialing calipers. You can fit them and make them into leading but because of the differentail piston bores you will get tappered wear on the leading edge of the pads.
8 piston calipers are OTT and usually dont work that well because they need 4 pads per calliper.
 
Progressive Parts, performance parts and tuning specialists