JabbaSport - Honest Impression

[markgre]

yeah its £200 for the disc but what is the fitting cost ?

 

[timbotdi]

I don't know mate - Allard did all the work as a job lot. I'm sure someone on here will know what's involved...

T

 

[devonmikeyboy]

Your looking at about £200 fitted no matter if you just get a disc or the whole SMF, pressure plate, drive disc and bearings done.

 

[aidy.t]

Well worth doing the clutch IMO, used to own a Bora 130 tdi, and i had Jabba remap on that. Problem is i asked Mike T to up the torque as i wanted it to come in with a big Slap, but guess what after 200 miles i glazed the clutch which made it slip every time the Torque started to build. Mike did warn me that this may happen. So i would go by his guidence. At the time the torque was around the 330lbft mark! but came in too aggresive. My Fault.

Your in safe hands with Jabba, they are very good and i wouldnt go anywhere else!

 

[olaf]

Sorry to dig up an old thread.

But how did it all go at Jabba in the end?

 

[markgre]

It was great. Fantastic service and now sitting on just under the 200bhp mark.

What a difference, only problem is now i want more !

 

[olaf]

Did you just get the custom map then?

Clutch upgrade? Anything else?

Think I may end up paying Jabba a visit.

 

[markgre]

It was just a custom remap, as they were fully booked to be able to get the clutch done on the same visit.

My fault for not being sure i wanted to go the whole hog at the time. Now just saving up for the new clutch and they have said they can then give the map a tweak to take into consideration the extra power it can handle.

Would recommend them to ANYONE !! So impressed, i dont know what else to say !

 

[devonutopia]

Beat any of my times on Colin McRae 3? I set a few new fastest stage times when I was there last a couple of weeks back.

 

[MattFrench]

My experience:

Leon fr 150,

RR at 157, was very impressed.
after a custom remap it produced 192. Not so impressed.

But these are only figures and are dependent on all kinds of factors. the drive is so much more exciting and smooth delivery. Impressed with the product but not impressed with jabba, if its your local place go there, but if not dont bother travelling.

 

[MattFrench]

Mark How long did then spend on your car, and what was its standard bhp, 198 is a impressive figure, was it done on their new rollers?

Ta

 

[chillcupra]

I wouldnt trust getting rrd at the same place you have the map.

 

[ryan_s3]

My Opinion of Jabba is split in two,one i think mike is a nice bloke and definetly knows his stuff.Then there are the "rest"..... Needless to say i would never use jabba again.

 

[chillcupra]

I am with ryan on this one. Dont trust Jabba personally.

 

[Deano_2104]

i had mine done at jabba, was very impressed with the mapping and service

clutch went last month so had to uprate it but that was expected when i did it

 

[strugers1]

so can i get mine chipped at jabba have the high end power but lower the low rev range torque?i got a bookibng for the 11th july i cant wait but i would rather a set of nice rims than a clutch

 

[strugers1]

sorry another question if my clutch does start to slip how long will it be roughly before it starts to go??

 

[Deano_2104]

mine never slipped at all and when it started after 7 thosand miles of it being remapped, it went within a week till i decided i wasnt going to risk destroying the flywheel. . . .

 

[strugers1]

thanks mate so what clutch did you get put in after??

 

[devonmikeyboy]

Helix and Sashs are the two best clutch manufactures. Sashs is a bit cheaper but holds less torque.