I found out today if you dont shut the boot properly the rear wiper or washers wont work.
found that out after 3 years ownership lol.
found that out after 3 years ownership lol.
Also another one, to make both left and right of your dual zone climate control go up as one, hold the AUTO button for 3 secs
how do you get the needle sweep?
Needs 'Staging' to be enabled by someone who has VAG.COM.
Plus it doesn't work on pre FL cupra's
Sent from my iPhone using Tapatalk
Found out by accident today, if you don't press the middle peddle when approaching another stationary vehicle....
Now they tell me!No middle pedal on mine...
To re-set the sevice indication (if your dealer forgets to do it like mine did....)
1. Press and Hold the Odometer knob in
2. Turn the ignition on (do not start the car though)
3. Turn the odometer knob to the right and hold for about 5 secs.
4. Release odometer knob and switch ignition off.
5. Start car, Service indicator should now be gone
electric mirrors if u twist the switch antic clockwise so it points backwards the mirrors fold up
couldn't find it posted
here's one for you, not useful just trivial. Noticed it with my PD and CR.
Say your on the motorway, set CC @ 70 and then reset your MFD and put it on Average speed, on both cars now it has stayed at 65 for many miles, just a fault with the calculation? or are the speedo's 5mph too high (would explain a few ppl's top speed figures )
This happens on my car too
I have even had cruise set at 70, reset the computer, waited as you do, maybe 15 secs for the computer to begin recording data, flicked into average mph, and low and behold 65mph.
Cruise control:<br />
Hold reset to speed up,<br />
Hold set to slow down. <br />
Flick the on switch half way to cancel. <br />
<br />
Just notice this owned the car 18 months.
Speedo will always read over by about 5mph at 70. The one on the trip computer will probably just be more accurate (digital display as opposed to analogue one for the speedo).