MBC install
Just installed my Forge Unos MBC, the reason i decided to install an MBC was because i was getting 1.8bar spikes and basically it was making me nervous.
Some people use this to increase boost by cranking on the Actuator, but i wanted to use it in conjunction with the N75 just to smooth out the spikes and i must say i was suspicious, i installed the device, went out and tweaked it to boost no higher than 1.6bar and it worked perfectly, boost guage did not spike over 1.6bar, so i was quite supprised how well it worked.
It bascially works when setup with the N75 by bleeding the excess boost off through a bleed hole, in my case anything above 1.6bar was bleed off.
You can use this device on its own to increase boost, but its not advised from what i read and if setup incorrectly will shorten the life of your turbo.
Really easy to install, the bottom nipple on the MBC T's into the boost line from the Charge pipe and the side nipple on the MBC T's into the connection from the N75 to the turbo actuator.
Nice little mod this, pic's below.
On another note, i got a new PCV from Forge, i can never remember Forge making one of these for the BAM 225 so when i found it on the website i was quite suprised, i could only ever find breather hoses for the LC in the past, just need to get it install now.