Sachs!

[MATTCR]

This may be a common topic im not sure, but im trying to find the specific parts list for what I need to upgrade my clutch to a sachs so I can source the parts over the internet.

Car: Cupra 150 TDI (2004)

If there are any parts that I 'may' or may not need, please list also as I want to get the full kit so i can get it all done at once.

Thanks in advance for any help!

 

[cupra_r_04]

Try Jabbasport,they are site sponsors on here.I got a SACHS clutch and flywheel off them.I found them v helpful aswell,I'm sure they will tell you what you need to know

 

[MATTCR]

Cheers

How much did you get bent over charged for fitting the kit?

 

[cupra_r_04]

I don't know exactly how much it cost me to get fitted cos I got a few things done to it.I paid €700 to get it all done,that included a full service inc timing belt and water pump,fitting the clutch and flywheel,a fmic and a few bits and pieces.judging by that I don't think you will pay 2much.

 

[vwbassett]

part nos are probably posted along side there parts on the vwspares website.

 

[hine81]

This may be a common topic im not sure, but im trying to find the specific parts list for what I need to upgrade my clutch to a Sachs so I can source the parts over the internet.

Car: Cupra 150 TDI (2004)

If there are any parts that I 'may' or may not need, please list also as I want to get the full kit so i can get it all done at once.

Thanks in advance for any help!

I'm with you on that mate i've had my 150 pumped upto 200bhp and after about 6 months my clutch has decided to start slipping i've been recommended Sachs but to be honest i don't know what I'm looking for?? should i be looking for a duel mass clutch any advice would be fantastic cheers

 

[MATTCR]

I'm with you on that mate i've had my 150 pumped upto 200bhp and after about 6 months my clutch has decided to start slipping i've been recommended Sachs but to be honest i don't know what I'm looking for?? should i be looking for a duel mass clutch any advice would be fantastic cheers

Yeah mine is only slipping below 2k revs really.

I believe the standard flywheel should be ok, unless when they get it off its fooked you can change to a single mass for extra £££.

Have had two quotes so far and both just under £900...!! !!