well yesterday i visited AMD for a stage 1 remap, i was lucky enough to get it as a birthday pressie. The other half has had it booked for months.To say i was excited would be an understatement. All in all it only took just under two hour from dropping the keys off. Although it felt a lot longer than 2 hours.
I was a little apprehensive that after running the diagnostic there was going to be a
problem (unlucky with previous car trouble), in fact it was quite the opposite which was a first lol. I was told she was in tip top condition, and after a run on the roller she was running an impressive set of figures for a standard car, although im not completely convince their right (dyno plot to follow shortly):
Pre Map:
244.20 BHP
234.0 ld/ft @ 3579 RPM
The after figures (With Piper Cross panel filter)
254 BHP
287.70 lb/ft @3959RPM
The BHP peak figure has only climbed 10 BHP, but in the mid range it has between 30 & 40 extra BHP.
The overall impression is the car feels so much more flexible, the extra poke certainly makes it presence felt. She now pulls really well from anything over 2k, much more than the graph would suggest, however the mid range is where it really shines!
it was suspected that the standard TIP is "pan caking" under high load and holding the peak figures back slightly. So this will be replaced at some point soon as well as the DV.
Since having a couple of cold starts it feel noticeable quicker than it did when u drove it home from AMD. So to summarise i am over the moon with the way the car feels.
Its been said many times before, but i'll say it again. i highly recommend AMD if you're looking for a remap. The service was first class, very friendly staff and great customer service. So thank you AMD.
More Euro trip photo's to follow shortly.