actuator seal

[cupra_jobe]

i noticed the other the seal on my actuator is split and leaking air.....

Question one is this easily replaceable? if so where from

also when i boost to about 1.6 bar after around 2-3 seconds it drops suddenly to 1.2 could this be because of the leak. or the way it has been mapped and i havent noticed it. I no it peaks at 1.6 and the runs at 1.2 before dropping off at the end of the revs. i just thought that between 1.6 -1.2 would be smooth drop.

Any help greatful cheers

 

[ibizacupra]

what actuator is on it?
if crimped together housing its not servicable

 

[cupra_jobe]

Sorry am not quite sure but cr turbos hybrided it around 2 months ago. I say seal it's actually a rubber bung that goes around the arm coming out of the actuator.

 

[ibizacupra]

when you apply a fixed pressure to the actuator it leaks way, is that what you see?

 

[cupra_jobe]

Yeh it leaks through the seal and as I prod it the seal closes up and seems to stop leaking or leaks less

 

[ibizacupra]

confirmed needs replacing then.

 

[cupra_jobe]

Is it easy to do? Where do I get one just ring CR? Could this be part of my pressure issue?