pressure

Hi :) My Leon had Seat 18s added to it before I bought it (x-demo) and so I was wondering whether the sticker with tyre pressures relates to the oroginal 17s that were fitted from the factory, or, if the pressures are the same regarless of which wheel you have? Thanks guys :)

done a load of searches before everyone jumps on it!!!!!!!! Seen craigs fitting guide!!!!!!!!! But still not sure as to whether i need another part or not, i have the adaptor to fit the sender but will i lose my oil light off the dash and if so do i need to buy a t piece??????????? If...

Just swapped the wheels around on my Fr TDI Altea to get even tyre wear, and went for a short burst and the tyre pressure monitor came on on the dash... Went to check type pressure notes in Hand book but does not give PSI - Bar readings in any of the pages given. Can someone advise me what...

Are they wheel specific? I mean if i bought some aftermarket wheels would they not work? thanks

When calculating the Pr for reading compressor maps should you use your peak boost or the boost that your turbo holds? I.e - I peak at 20psi, but hold 16..... Thanks Raf PS also anyone know the volumetric efficiency of the 1.8T lump?

Does/has anyone use an electronic tyre pressure monitor ? the type that shows you the temperature & pressure from a transmitter in your tyres valve, I'm thinking of getting one as 205/40/17's are difficult to tell by looking as they are so low profile & manually checking them is a pain. Any...

hi newby here does anyone know what the tire pressure needs to be on 18inch alloy wheels cheers sam

does anyone know where the best place is to buy a four bar fuel pump and pressure regulator? thanks in advance for help :thumbup:

gonna get a pressure washer of my own to save steling my grans every week! any suggestions on what to get and where to buy! im thinking karcher k5 the one with the round one for easy storage any ideas thanks!!:confused:

Hi , I just got two error codes i was wondering if anyone could help me out a little cos I dont know what i need to do to fix the problem . 00285- abs speed sensor front right (g45) 012 electrical fault in circuit and 00792 a/c pressure switch (f129) 03_10 no signal could someone...

Can someone recommend a decent pressure washer that is able to draw water from a water butt rather than a tap? I heard some some Karchers do but not sure if they all do. Can they all do it out of the box or do I need to buy extra accessories to do it?

Hi If you specify a car with tyre pressure monitors from factory, how will this work if you then change the wheels? I am assuming the sensor must be in the wheel as I read on the wall of a tyre fitters the other day that you must tell them before having new tyres fitted if you have them...

After a couple of months of driving and being generally lazy I decided to check my tyre pressure and noticed my tyres were down at about 29 psi which is a reasonable amount down on the recommended pressure. Now I would have thought the tyre pressure monitor feature would have picked this up...

I've got 205 40 17 tyres on my Cupra and was wondering if anyone has some reconmendations for pressure (front and rear)??? Cheers!

Ive done searches on here and got nothing. Ive also spoken about this DTC before but got limited response. I've checked the vag-com section and it relates to the dump valve. But the D/V is fine, its a forge recirc (dont know what model as i stole it off of my mates golf. and now on to my LC...

http://www.homebase.co.uk/webapp/wcs/stores/servlet/ProductDisplay?storeId=20001&langId=-1&catalogId=10101&productId=609010 Tired of cleaning the car with mer shampoo (plain useless), I have decided on a pressure washer and some snow foam. Any good reason not to buy that one from homebase...

Can anybody please tell me what the size is of the bit you need to remove to put a t piece in to set up an oil pressure gauge??? :shrug: Opinons i have are: 1/2" unf 1/4" npt 1/8" bsp 1/8" npt 3/8" bsf 3/8" npt m10x1.0 m10x1.5 m12x1.5 m14x1.5 m16x1.5 m18x1.5

I've just got a nomad pillar for my cupra and a stealth boost and oil pressure gauge. i am clueless of how to wire them in and so havent even bother to get them out of there box yet!!!! does anyone on here fit them???? if not does anyone know any company in the south that fits them???? Please...

Hi people. I was just wondering if anyone knew the correct tire pressure for the standard 13" wheels on the mk2 Ibiza? As the "sticker" under the fuelcap is faded on my car! (previous owner! [:@] ) ps- does ANY1 else still have the original 2 piece bumper? or have u all changed it for the 1...

can a small difference in tyre pressure such as about 1 or 2 psi, make a big difference in the quality of the ride in the car? i have a 1.4 99 plate with mk3 cupra wheels and 195/45/16 tyres, and i normally keep the pressures around 32psi front and 30psi at the rear i checked these the...