I've had no luck finding this block that fits onto the post-cat lambda sensor when a decat has been fitted. I've got the car booked in for a custom remap which will remove the sensor from the ECU but can anyone direct me to this separating block for the time being?
Thanks
Dan
Hi guys, I'm in need of some help.
The last few weeks I've been having several codes, and I am not quite sure what is going on.
16514/P0130/000304 - Oxygen (Lambda) Sensor B1 S1: Malfunction in Circuit
Possible Causes
* Oxygen (Lambda) Sensor Heating Bank 1 Sensor 1 faulty...
So my car went for mot today
it passed the emmisions test somehow even though vagcom is telling me that the pre cat lambda sensor is dead i also have a sports cat!
i ordered a new bosch genuine sensor to replace it but didnt get delivered in time for mot so i decided just to give it a...
As I understand with revo stage 2 the rear lambda sensor is mapped out, so what have people done. Do you have to leave it in its bung.
Reason I ask is I have taken mine out from the exhaust and fitted a blanking plug. But Iv left it plugged in and just tucked it away in my engine bay.
But...
I'm using Vag-Com 3.11 and in group 031 I'm getting a reading in Volts and not the actual AFR (lambda).
Does this mean my lambda probe is narrowband? I haven't seen the voltage on this channel fluctuate other than 0-1V. Is the reading wrong or has something to do with the lambda probe itself...
Could fitting an interior LEDs cause the emissions warning light to come on?
Hi all,
Just a thought - a couple of weeks back I fitted an LED in the centre interior light (in the middle of the two map lights). I fitted it, tested it and left it at that - without starting the engine.
The...
Hi all, I've been having some missfiring problems with my 2000 leon 1.8 20vt. So i bought a vag com and these are the faults:
Address 01: Engine
Controller: 06A 906 032 T
Component: 1.8L R4/5VT 0003
Coding: 05510
Shop #: WSC 06441
3 Faults Found:
16518 - Oxygen...
My car was driving really rough and doing bad mpg, so plugged in vag com and it said it was the lambda sensor. So just fit a new lambda sensor (from seat) and all was good again then drove bout 100 miles then this flashed up.
1 Fault Found:
16514 - Oxygen (Lambda) Sensor B1 S1: Malfunction...
Hey, can anyone suggest a good way of removing the fron lambda sensor on my audi S3? Elsa shows a special tool is needed, like a cut open socket, can anyone else share their methods of removal? thanks :rolleyes:
James
hi all just wondering if anyones had problems with lambda probes seizing in? and any ideas...ive tried a spanner...cracked it off and now its stop turning all together. Id try and get the probe hot but ive cut the wires off it :cry: any ideas?
hi all i am fitting my new lambda sensor tomorrow on my leon cupra 180 on a 52 plate does anybody have any information on where the plugs go and also taking the old one out
thanks
Hello everyone, please bear with me as I am new to all this forum stuff.
I have a 2,0l Alhambra with ady engine, the lambda voltage is showing arond 4v, I have checked the lambda heater voltage and found that to be only 5.5v instead of the 11v. Has anyone had a similar problem and if so how...
Hi all,
Had the engine check light come on whilst driving today so on arrival home plugged in the scanner and revealed
PO136 - O2 sensor circuit malfunction, Bank 1 Sensor 2
Having checked the second lambda sensor i found a dry connection and 2 wires broken.
So my question is anyone...
Hello,
I have a Leon 1.6 16v AZD engine, ran the vag-com on the car due to engine light coming on.
Control Module Part Number: 036 906 034 CP
Component and/or Version: MARELLI 4MV 3956
Software Coding: 00031
Work Shop Code: WSC 06441
Additional Info: VSSZZZ1MZ2R022417...
Hi all ,
I have an eml light on. done a quick scan with vag com and got these results.
Is it just a new pre cat sensor required or is something else at fault as this is the five wire type an not very cheap to buy.
would like to be 100% sure
VAG-COM Version: Release 607.3-UD...
EM light is coming on after aprox 100miles when it has been reset with vag-com. The code is as follows.
Control Module Part Number: 06A 906 032 HN
Component and/or Version: 1.8L R4/5VT 0002
Software Coding: 11510
Work Shop Code: WSC 66565
Additional...
Since getting the car back to what i thought was full health with the aid of a genuine MAF, i have noticed that the MPG is still low very low 24MPG for a 160mile motorway drive at 70-80mph.
I am now convinced that this is Lambda related as the car was way rich last time it was tested. I am...
I have the fault codes 17511 and 17524 which both relate to the heater circuit on the lambda sensor before the cat.
Reading past threads, its a good idea to check the wiring and also the resistance in the circuit before shelling out on a new sensor.
Has anyone done this before and can tell...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.