joint

could any one give me a rough price for a new cj joint with fitting and do you no if this is normaly covered under warrenty??:censored:

finally got the servicing finished on the valver and fitted new springs/dampers all round (just finished the fronts). took it out for a spin and in the excitement of being able to tank it round bends at obscene speeds I got a bit aggressive with the gearchange, now I have clunking coming from...

We had to get recovered today and the RAC guy said the outer CV joint on the drivers side had failed. Where the best place for a new one and are there any guides to fitting it? Would it be the same/similar to doing it on a mk3 golf? I've got a Haynes for that. Thanks in advance.

my cars in for a service, and i've been told that a ball joint is leaking grease. i'm guessing they will need to replace the ball joint, anyone know how much a ball joint will cost to replace myself? its driver side one. thanks

Is it possible to buy this part separate, or do I have to buy the whole driveshaft with both joints?

wheres the best place to get a price for a ball joint or how much are they .ive got an 03 lcr

Evening all, Had a bit of a scare on the way in to work this morning! Basically, I'd noticed a knocking when braking/accelerating the previous day and was going to get the car booked in today, however the car obviously wasn't happy with that and decided to let me know it needed attention...

Comments please on the following. Normal warnings apply. Working on cars is dangerous etc. It's not my fault if anything is wrong in this thread and you die. or break something.......

Does anyone have any idea how the outer CV joint is attached to the driveshaft? I've got the joint out of the hub and cut the old boot off, but I'm stuck.:confused:

The inner joint on my offside driveshaft is throwing grease out. Although the large clip is still in place on the rubber gaiter, the grease is coming out from that inmost end (beyond the clip). a) should I get the complete kit and replace the whole inner joint? b) there is an end cap on...

My wonderful Toledo V5 has started to make a clicking/grinding/clunking noise from the drivers side (its done 99050miles 4000 in two months lol). It happens with the clutch depressed or not depressed and only when no throttle is applied and no brakes are on i.e coasting in a straight line and...

Can anyone tell me if a new bottom ball joint comes supplied with a bracket and 3 bolts? Reason for asking is that I've removed my suspension arms to get them rebushed (powerflex). I decide it was easiest to undo the 3 bolts on each arm that hold the balljoint, leaving the joint still...

are all the cv joints the same, will the cupra one fit the cupra r one or is it more stronger? also where can i buy one from, other than the dealers that are rip off merchants.

I went to tax my car this time last week (2nd May) and handed over my documents to be told i needed an MOT. I had it in my head the car was registered 02/07/03 but instead it was 02/05/03:censored: so obviously she never gave me the car tax. It has risen from £90.75 to £104.50 aswell:censored...

Whilest changing the front brake pads sunday afternoon I noticed on the drivers side few lumps of black stuff on the top of the wishbone...i went to wipe it off only to find it as thick black grease and knew at that point where it had come from and noticed the rubber gator was split on the...

Just hoping for some ideas, basically, my car went for its first MOT this week, failed on the near side bottom ball joint only, the garage (non Seat, local garage) ordered a replacement joint from SEAT, all fitted went to pick it up today. As soon as I drove off, it didn't feel right, first...

I am on my third set of cv boot covers ( the ones at the wheel hub). Original set went @ 17k, replaced them with the universal boots that push over the joint (using the cone to fit), The replacement set lasted about 8k just seemed to wear through not cut. On another set now. I have fitted Cv...