morning all
i got up this morning and decided to check my oil after pulling the dipstick out to check it i noticed the dipstick didnt come out like it should the housing snapped off about 2 inches from the to. so now it doesnt like it should.
anyone else had this problem and would this...
As thread title suggests I have my thermostat housing to replace as some point, Im hoping this weekend.
1st question, What is the best way to drain all the coolant out??
I read the 'suggestion' in the haynes manual but it isnt that easy to follow.
2nd question, Any suggestions for...
today i serviced car new fuel filter air filter oil filter oil plugs and went to clean egr valve out and i broke off the plastic connector which runs from thermostat to coolant bottle so i got to get new one from seat its on order and will be with me wed so that really made me mad i then had a...
I've just got my LCR and realised its missing one of the rear numberplate housings, nothing there, just a hole :think:
Does anybody know the part numbers of what i'd need? And would it be a rear bumper off job?
hi guys in=m in the middle off spraying inlet manifold and i want to do throttle body housing same but wanting to throttle housing off to clean propaly i no its 4 bolt to take off and 2 plugs ect just want to no what to look out for taking this off ect touching inside clean throttle housing any...
Had a search but didn't find any specific references that helped. Does anyone know what tool you need to undo the screws that hold the MAF element in the housing?
I need to remove mine to refit it into a LCR 3" housing but all the tamper-proof and torx heads we've tried don't fit properly...
Hi guys, needing these two items to complete my 290bhp conversion.
Can anyone tell me part numbers or best place to go to get them.
Also,
is all i need the MAF housing or the sensor too?
Thanks
Walshy
ps i have done a search and have had no luck
Does anyone know where I can get one of these?! I've searched all over the net, rang GSF (who were as much use as a chocolate tea pot) and various forums but can't find them anywhere.
Where did the big turbo guys get your bigger maf housings from?
Cheers.
I have been told that i need a new thermostat housing to stop my cordoba overheating, any ideas where i can buy one ? I have tried breakers.yard.com with no luck and the Official Seat site no longer lists spares for the Cordoba? Thanks for any help.
My car has been making strange noises. I took the air in take apart and to the right of the throttle housing is fine, to the left the big fat pipe that goes down to the intercooler has oil in it. Not lots but enough to make me think that is not corect?
Any ideas how oil could get there and...
I noticed yesterday that there is a fair bit of oily residue around my EGR housing, looks like it's come out under pressure (similar appearance to the stuff you sometimes see around boost pipe joints etc).
Is this normal ?
This should be irrelevant, but my EGR is disabled. Whether it's...
Hello
i noticed this mornign that there is a lot of condensation in the housing to my 3rd brake light under the spoiler, there is probably enough in there to start a small pool of water :censored:. on the front nearside light housing i also noticed some 'mist' on the inside of the light...
While fitting a new air box yesterday I noticed the MAF has a plastic grid like cover over each end. Is there any merit to removing this? Or is it likely to cause more problems that it's worth?
It just seems more of an obstruction than the insides of the airbox. But I don't want to screw up...
I've just changed the oil on my 99 V5 which was going well until I hit the oil filter housing and put a small crack in it. So, at the moment I can't drive the car as oil will poor out at an alarming rate if the car is started. So I need a new filter housing (the black plastic part). Does...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.