bleeding

Morning all, Had a call from the mrs last night who has had my car for the last few days, she called to say I think the car is leaking oil a bit. I said don't use the car again until I come home a bit later on. A bit of a leak, it was like a bloody pool on the floor. I asked her if she...

I need a guide and equipment. I can have two people if required. I know the basics, but ive always been the person pushing the brake pedal, not at the other end. Thanks

Ok, I have been a bit eager and tried to bleed my brakes the same way I have done on all my other cars (without any prblems), however I now seem to be unable to get any pressure in the brake system:doh:. I have done a search and found that I should have used a pressure bleed and not the old...

Need to change the clutch master cylinder on my LCR, doesn’t look to bad a job but I understand it’s a pig to bleed. :( Any advice would be appreciated.

Right this weekend or next ( assuming bracket parts turn up etc ) I'm going to be replacing all the brake calipers on the Cordoba. Mk4 Golf rear calipers with goodridge hoses, and LCR brembos with goodridge hoses. So I need someone to explain how I'd go about doing all this? So far I've...

im changing my rear disks and pads soon, and also my car is now over 2 years old and got 18k on the clock, so brake fluid change is needed. ive got a gunsons ezeibleed that i used to do my 312mm conversion. my question is, is this good enough to do a full fulid change on a car? and secondly...

OK, so ive lost all fluid out of brakes due to a small problem with pads, any how, now im ttrying to re-fill the pipes etc...... can any one give some helpful tips on how i should go about doing this? do i need to bleed 2 whells at once or can i do it one at a time? :confused: :blink:

After doing some work on my brakes over the weekendI need to bleed my brake system. I have an 02 reg Leopn Cupra by the way After doing the work and bleeding the rear calipers I had no pedal at all:scary: Then after doing a search on here I found out that I needed to have the engine running...

How do you bleed the radiator basicly cheers?

hi guys looking for some help here my clutch pedal bust open the other day and ive since had it welded up and a new clip fitted but ime having problems bleeding the clutch do you need to put pressure on the master cylinder reservoir or anything else:confused:

Hi, Is there any trick to this or can you just do it as normal? Tried it today in this order: right rear left rear right front left front as it says in haynes manual but got a spongy pedal. It mentioned something about load sensor valves but not sure if this model has them? Maybe...

after changing a rear caliper and then bleeding the brakes i find that the brake pedal is spongey and travels to the floor. i have tried bleeding all the brakes but find i still cannot get a solid pedal. is there a certain seqeunce to bleed the brakes. can anyone please give me some advice. cheers!