Hi all this is just a guide on how to wire up the autogauge boost and oil temp gauges!!
Right the boost goes like this...
The Red.. goes to the black/grey on the dimmer light side
The Black is the earth so put that to the brown
The orange gets tucked away
Then attach your boost pipe
The oil temp goes like this...
There are 6 wires in total so i'll start with the thicker bunch first
The red needs to goto the blue/grey and double it up with above
The black is again earth so this to brown and double it up with above
The orange again is not needed so put that away to
Now the thinner wires, these are the sender wires
The red is needing permanent power so put that to the black/red wire
The green goes to the sender for the oil temp, this will then attach to the white on the oil sender
The black again is earth so put that to the brown with the others
On the oil sender i had 2 wires white and black, the white goes to the gauge and the black needs to be earthed i just put this to a bolt in the engine bay
Hope this helps guys!!
Right the boost goes like this...
The Red.. goes to the black/grey on the dimmer light side
The Black is the earth so put that to the brown
The orange gets tucked away
Then attach your boost pipe
The oil temp goes like this...
There are 6 wires in total so i'll start with the thicker bunch first
The red needs to goto the blue/grey and double it up with above
The black is again earth so this to brown and double it up with above
The orange again is not needed so put that away to
Now the thinner wires, these are the sender wires
The red is needing permanent power so put that to the black/red wire
The green goes to the sender for the oil temp, this will then attach to the white on the oil sender
The black again is earth so put that to the brown with the others
On the oil sender i had 2 wires white and black, the white goes to the gauge and the black needs to be earthed i just put this to a bolt in the engine bay
Hope this helps guys!!
