-
Welcome to our new sponsor Lecatona, a brand dedicated to enhancing performance for VAG group sports cars, including SEAT, Audi, Volkswagen and Škoda. Specializing in High Pressure Fuel Pump (HPFP) upgrades.
-
The forums will be offline for maintenance on Friday 15th November at 10pm for up to an hour. Thank you for your patience.
as you look down buy the turbo should see black and brown connectors you want the brown one took mine though the grommet for left hand drive then in to passenger footwell.
cheers nick
cheers nick
Cheers Nick, So i hook the my signal wire from the gauge up to the brown one, which wire on the brown one.
Baz I hooked up the one Brad put into my car, it jumps all over the place because its not getting the right signal. I fear yours may do the same unless its the correct format for the lambda probe...
I remember looking into this loads and it turned out the only way to have an accurate af gauge was to plumb in a dedicated wide band lambda probe for your gauge which was a jaw dropping £300 odd
I remember looking into this loads and it turned out the only way to have an accurate af gauge was to plumb in a dedicated wide band lambda probe for your gauge which was a jaw dropping £300 odd
The A/F gauges do jump all over the place, i've seen quite a few on high powered cosworths and they all hover about.
baz think that it's the gray one that mine went on to i'll get a piccy of it tomorrow and put it up for you.
cheers nick
cheers nick
it will jump form side to side on idle and cruise for example... off gas overrun is red, on gas should be in green.. about all its good for is an indicator on full boost.
wideband is the proper job. narrow band is pants
wideband is the proper job. narrow band is pants
Can anyone recommend an A/F gauge which will use the LCR wide band sensor accurately.
I've heard bad things about patching it in to the current loom , wrong signals to the ECU etc.
When i do mine i'm gonna fit a seperate boss for another probe into my downpipe , you can get the probes from Eurocarparts etc , there not very pricey.
When i do mine i'm gonna fit a seperate boss for another probe into my downpipe , you can get the probes from Eurocarparts etc , there not very pricey.
These plugs mate.
We have just fitted a wide band lambda setup on a mates Prelude Turbo due to the rubbish readings from the narrowband, now works brilliant.
We have just fitted a wide band lambda setup on a mates Prelude Turbo due to the rubbish readings from the narrowband, now works brilliant.
Similar threads
