Project Carbon - Paint Correction Detail - Pic Heavy!

jonjay

50 Years of 911
Jun 27, 2005
5,843
1
Essex
Project Carbon Detail

Another detail that has been a very long time coming! The car itself is a great example to the LCR club as a lot of thought and attention has gone into it from the modifications to the engine bay bling. Looking around the car you can tell that no expense spared in its maintenance over the years and as Daz said to me a few times now, he cleans it twice on a weekend if it gets dirty on the Saturday!

The detail was very very last minute! It was decided on the Saturday morning that we would do it as BHP show was coming up. Couple of hours later….


11AM - I am presented with this:

IMG_1434.JPG


IMG_1435.JPG


IMG_1437.JPG


IMG_1438.JPG



Engine bay pic taken from DK’s readers ride thread.
untitled-39-1.jpg



Taking scope of the job at hand I chose the weapons and jobs we were both going to do for the day as time was against us. I wanted to try and do the best job possible so the car looked great for the BHP show and I was also very conscious that silver cars are so dam difficult to make gleam so I chose the Werkstat system to add some depth to the paint.

Products
Wash n Drying
Meguiar’s NXT Tech Shampoo (wheels)
Dodo Juice Supernatural Shampoo (body)
Chemical Guys STRONG WASH - Bug Tar & Grime remover
ValetPro Snow Foam
ValetPro Tar and Glue remover
CarPro Iron X
Bilberry Wheel Cleaner
Meguiar’s All Purpose Cleaner
Autobrite Polar Express drying towel
Chemical Guys and Meguiar’s microfibres

Body Work
Sonus Green clay
Menzerna Power Finish (203S)
Menzerna Final Finish (106FA)
Dodo Juice Lime Prime (hard to reach areas by hand)
Dodo Juice Need for Speed (door shuts)
Meguiars Last Touch

Glazes, Sealants and Waxes
Werkstat Prime Acrylic
Werkstat Acrylic Jett
Werkstat Acrylic Glos

Plastics, Rubbers, Metal and Glass
Meguiar’s Endurance Tyre gel
Meguiar’s NXT Metal Polish
Autoglym FastGlass Cleaner
Autoglym Vinyl and Rubber Care
IPA

Tools
Meguiar’s G220 DA
Dodo Juice Spin Doctor Rotary
Karcher Pressure washer
Sonus foam applicators
Sonus Green Polishing Pad
Sonus Orange Swirlbuster Pad
EliteCarCare Brushes
EZ Wheel Brush
Vikan Brushes
3M 3434 Masking Tape


The wheels were cleaned with a 4:1 mix of Bilberry Wheel Cleaner (changed to a weird colour recently). The arches were spray with a 5:1 mix of Chemical Guys Strong wash – bug and tar remover. This really helped soften up and breakdown the tar on the wheel arches ready for scrubbing later.

WHEELS
IMG_1440.jpj


IMG_1445.jpg


IMG_1447.jpg


IMG_1453.jpg


IMG_1454.jpg
 
Last edited:

jonjay

50 Years of 911
Jun 27, 2005
5,843
1
Essex
IMG_1455.jpg


IMG_1458.jpg


IMG_1460.jpg


IMG_1464.jpg


IMG_1465.jpg



At this point the process was not over yet with the wheels. I had some Iron X ready to give the wheels more of a deep clean as I noticed some Iron and heavy brake dust deposits that wasn’t moving. I didn’t have much Iron X so had to be a bit liberal in its application. It did the job though and I got 1 litre of Wolfs Chemicals Brake Duster coming soon which I am pretty excited about.


IMG_1467.jpg


IMG_1469.jpg


IMG_1470.jpg


IMG_1471.jpg


IMG_1472.jpg
 
Last edited:

jonjay

50 Years of 911
Jun 27, 2005
5,843
1
Essex
IMG_1474.jpg



The arches were then spray with Megs APC and given a good scrub, they needed it!

IMG_1475.jpg


IMG_1478.jpg


IMG_1480.jpg



Disgraceful DK LOL!
IMG_1481.jpg



CAR BODY CLEAN STAGE

Car was snow foamed with Valet Pro Snowfoam and left to soak for 6-7 minutes.

IMG_1489.jpg


IMG_1490.jpg


IMG_1494.jpg
 
Last edited:

jonjay

50 Years of 911
Jun 27, 2005
5,843
1
Essex
Car was then rinsed and all crevasses, rubbers and plastics were cleaned with Megs APC

IMG_1498.jpg


IMG_1499.jpg


IMG_1500.jpg



A lot of dirt came out of the window seals!
IMG_1501.jpg


IMG_1502.jpg



The car was then re-foamed and washed with Dodo Juice Supernatural.
IMG_1505.jpg


IMG_1506.jpg


IMG_1507.jpg
 
Last edited:

jonjay

50 Years of 911
Jun 27, 2005
5,843
1
Essex
Claying gave some big surprises. We had a lot of red paint overspray all over the body of the car. DK quickly ascertained it must have been when he had refurbished his callipers. Quite shocking as he literally covered everything so a lesson to all to be very careful!

IMG_1510.JPG


IMG_1511.jpg



There were some big tar spots that needed extra attention. ValetPrp Tar and Glue remover used to good effect.

IMG_1512.jpg


IMG_1514.jpg


IMG_1515.jpg


IMG_1517.jpg


IMG_1522.jpg
 
Last edited:

jonjay

50 Years of 911
Jun 27, 2005
5,843
1
Essex
CORRECTION STAGE

Car taped up.
IMG_1526.jpg


IMG_1528.jpg



I started off on the right rear quarter of the car so see what worked best. Pulled out the Rotary, Menz IP and elite car care heavy polishing pad. This combination worked (got good shine and correction level) however it was such hard work as the conditions were too hot. The polish was drying out quicker than I wanted and the panel was getting a little too hot for comfort. I decided to use the DA to reduce the heat on the panels and switch to 203S. This was a great combination and produced great results. I tried the rotary again but I just was not happy with the heat generated on such a hot day in the sun.

IMG_1533.jpg



Rotary lifted quite a bit of dirt from the paint
IMG_1534.jpg



Moved onto DA to keep heat down
IMG_1539.jpg


IMG_1540.jpg


IMG_1541.jpg


IMG_1542.jpg


IMG_1544.jpg


IMG_1545.jpg
 
Last edited:

jonjay

50 Years of 911
Jun 27, 2005
5,843
1
Essex
The bonnet needed two hits to get rid of heavier swirls and RDS.
IMG_1549.jpg


IMG_1552.jpg



I had a tad problem midway through the correction stage! SHOCK HORROR!

IMG_1556.jpg


Only purchased this G220 four months ago and hardly used it as I have been using the rotary more and more. I tightened the screws up and normal operation resumed but a little concerned what damage this may have caused internally.

Whilst I was machine polishing DK got to work on all the door shuts. He spent a lot of time on shut and it really shows. He added Dodo Juice Need for Speed on his wish list already.

IMG_1555.jpg


IMG_1559.jpg


IMG_1560.jpg


IMG_1562.jpg


IMG_1563.jpg


IMG_1564.jpg


IMG_1570.jpg
 
Last edited:

jonjay

50 Years of 911
Jun 27, 2005
5,843
1
Essex
IMG_1571.jpg



The whole car was corrected with the 1 stage polish and I was pretty pleased with 203S performance thus far. On some panels I mixed some 106FA to get them more depth and a refined finished.

IMG_1568.jpg


IMG_1569.jpg


IMG_1572.jpg


IMG_1574.jpg


IMG_1577.jpg


IMG_1578.jpg


IMG_1580.jpg


IMG_1581.jpg


IMG_1588.jpg
 
Last edited:

jonjay

50 Years of 911
Jun 27, 2005
5,843
1
Essex
IMG_1589.jpg



I am a big fan of Werkstat products and thought it was a good idea to use these as Daz could then top up the protection at a later date as he has these also. Werkstat Prime Acrylic is a fantastic all in one polish and got great cleaning and protection agents in it. I applied this all over the car with a DA working it in at a low speed (2) and finishing off at a higher speed (4).

IMG_1590.jpg


IMG_1591.jpg


IMG_1592.jpg


IMG_1593.jpg



Nearly forgot the exhaust!
IMG_1594.jpg


IMG_1596.jpg


IMG_1597.jpg


IMG_1600.jpg
 
Last edited:

jonjay

50 Years of 911
Jun 27, 2005
5,843
1
Essex
The car was then protected with Werkstat Acrylic Jett and finished off with Werkstat Acrylic Glos.

IMG_1602.jpg


IMG_1603.jpg


IMG_1604.jpg


IMG_1605.jpg



I am over the moon with the results after 9 hours later of non-stop work to beat the sun. Here are the results.


RESULTS

IMG_1606.jpg


IMG_1607.jpg


IMG_1608.jpg


IMG_1609.jpg


IMG_1611.jpg


IMG_1612.jpg
 
Last edited:

jonjay

50 Years of 911
Jun 27, 2005
5,843
1
Essex
IMG_1624.jpg


IMG_1625.jpg



Big thanks to DK for providing the car for me to work on, hope you enjoyed the detail as much as I did!


Detailers Notes
- It is always good to detail a mate’s car because they like to help! Lol!
- Really need to watch the heat on the panels with a rotary especially when working in the elements.
 
Last edited:

Oj 89

Senior junior member
Aug 19, 2008
1,747
5
NW Kent
Nice to see a car I know detailed. I'm astounded at the results from cleaning mostly. Find it hard to believe that DK would miss anything on his car! Makes an already good looking car even better.

Detailers Notes
- It is always good to detail a mate’s car because they like to help! Lol!

Know who I'll be getting to do my car when I get a decent one.

Mighty good job! :clap:

edit: ignore the post thumb down thing. No idea why that came up :p
 

t0m

LCR 225
Apr 29, 2007
8,133
7
Kent
Oh my god, that looks so so good! Fantastic work Maz! Amazing to see dirt coming off of DK's car haha :)

Would you fancy attacking my car the weekend before the Bromley Pageant? :whistle: lol
 

jonjay

50 Years of 911
Jun 27, 2005
5,843
1
Essex
Oh my god, that looks so so good! Fantastic work Maz! Amazing to see dirt coming off of DK's car haha :)

Would you fancy attacking my car the weekend before the Bromley Pageant? :whistle: lol
Cheers Tom!

When is the pageant? Give me a PM and we can sort something out. :)
 

D.K

LCR 225
Oct 24, 2007
6,408
3
se london
Massive thanks to Maz for doing such a good job :thumbup:

It was dark by the time I got home Saturday night and under the street lighting there were no visble swrils :D
 
SEATCUPRA.NET Forum merchandise