• Guest would you be interested in CUPRA or SEAT valve caps? let us know in the poll

  • Welcome to our new sponsor Lecatona, a brand dedicated to enhancing performance for VAG group sports cars, including SEAT, Audi, Volkswagen and Škoda. Specializing in High Pressure Fuel Pump (HPFP) upgrades.

horrid wiring

raepaul

Active Member
May 27, 2009
71
0
well i noticed i had a few lights out the other day so went to change them, i thought it was weird as it was tail, sidelight and brake light but al just on the driver side. put in new bulbs and switched the lights on and guess what..... pop. they blew again.

anyone have any ideas? diy job or take it to a auto sparkie?
car is a mk3 tdi 90

any help appreciated
 

Daymo

Low and Slow..
Jul 22, 2008
428
0
Scarborough/Sheffield
well i noticed i had a few lights out the other day so went to change them, i thought it was weird as it was tail, sidelight and brake light but al just on the driver side. put in new bulbs and switched the lights on and guess what..... pop. they blew again.

anyone have any ideas? diy job or take it to a auto sparkie?
car is a mk3 tdi 90

any help appreciated

try checking your fuses mate, they may have blown.
 

raepaul

Active Member
May 27, 2009
71
0
the fuses are all fine mate. could it be an earth problem? i just dont want to dig into all the wires if i end up looking in the completely wrong place
 
Feb 25, 2007
1,068
0
cheshire
clean all the bulb holder up make sure there is no rust or anything, check your wires for breaks its posible one is split and shorting outr on the body
 

lemonslap

In The Know
Mar 14, 2009
320
1
Kent
well i noticed i had a few lights out the other day so went to change them, i thought it was weird as it was tail, sidelight and brake light but al just on the driver side. put in new bulbs and switched the lights on and guess what..... pop. they blew again.

anyone have any ideas? diy job or take it to a auto sparkie?
car is a mk3 tdi 90

any help appreciated

Also check the output from the voltage regulator this can cause these sort of problems (should be about 14.4v with the engine running)
 

raepaul

Active Member
May 27, 2009
71
0
all the connectors have been cleaned up, they were all free of rust and corrosion anyway but thought id clean them anyway.

ok cheers, i will try that and let you know if i get it sorted or not.
 
Progressive Parts, performance parts and tuning specialists