PCD adapters

[C3 LJG]

Does anyone know if you can get PCD adapters for 4x100 to 5x112?

Have a little plan just not sure if its possible

 

[ibizacupra]

big audi fitment on 112's

 

[C3 LJG]

Thinkin merc!

 

[ibizacupra]

hmmm dont forget spigot bore too

 

[Mark@VAGWORX]

Best of my knowledge 4x100 to 5x112 is a no go as the bolt holes overlap. You'll need a rethink matey.

 

[Forbez]

LOL i've been looking at exactly the same thing, and unfortunately, i get the same response !

And yes Bill, they were audi!

 

[ibizacupra]

Best of my knowledge 4x100 to 5x112 is a no go as the bolt holes overlap. You'll need a rethink matey.

stagger them then surely?
thickness may be an issue to allow a depth of spacer to be secured to hub, in counterbored holes, and then studs from spacer to the 112pcd. would have to allow for this extra ET (off the wheel)

eg: 25mm thick conversion spacer would take an ET42 wheel to an effective ET17

 

[Mark@VAGWORX]

Apparently, the only easy way to run 5x112 is to convert to 5x100 first!!.......not exactly a 5 minute job

 

[Forbez]

What about fitting 4x100 to 5x100, and then 5x100 to 5x112?

LOL

 

[ibizacupra]

Apparently, the only easy way to run 5x112 is to convert to 5x100 first!!.......not exactly a 5 minute job

being a sad git I just drew 4x100 into 5x112 and yep.. intersection of holes on one of em.

 

[davidol]

leave a stud out then ?







that was just a joke by the way