I was just wondering if anyone could tell me if a LCR splitter could fit on a standrad front bumper on a 2001 leon S?? And how hard it would be to do?? 
LCR splitter on a standrad leon S Front bumper
- Thread starter marcuswomersley
- Start date
Only issue you might come across is it sitting too far forward - the pre-facelift bumpers curve more at the bottom so the flat part starts further under. The guide linked to is for the facelift bumper
I reckon you'd need to trim approx the equivalent of "the width of a roll of duct-tape" from the ends of the splitter to get it to sit properly.
Then just get some self tappers and away you go!
I reckon you'd need to trim approx the equivalent of "the width of a roll of duct-tape" from the ends of the splitter to get it to sit properly.
Then just get some self tappers and away you go!
I think ill have to get ma self one
I see that you have all your bumpers fully colour coded.. is this an expencive, hard job to do??
I see that you have all your bumpers fully colour coded.. is this an expencive, hard job to do??
where and when is the meet? my car isn't really modded, but I want to see some of the LCR beasties in the flesh... D.K JonJay Skorchio etc... pics apparently don't do them justice!!!
It is very easy.. would recommend it to anyone who wants a cheap easy mod
I cant put any pics up untill ive made some more posts
I cant put any pics up untill ive made some more posts
Similar threads
