Hi guys i recently just got my hands on an ibiza cupra R iv been looking around for the best place to get it remapped been in touch with a few places one in particular was extremely helpful (badger5) spent a good bit chatting to him he mentioned a wideband conversion i was just wondering if there is anyone that has had this done and if yhey think it was worth it..? Obv you would need supporting modsas ot sits i have below
Tsr rods
Wossner low compression pistons
660cc injectors
265lph fuel pump
4fpr
3" maf housing
Fmic
Wmi
Induction kit totally sealed green enclosed
Gt28 turbo (forget the model)
G60 lightened flywheel
Vr6 clutch
Pelloquin LSD
Vibratecnics mounts all round
Polybushed all round
Front and rear strut braces
3" downpipe
2.75" jetex stainless 100 cell sports cat
According to revo a stage 3 with these mods expects between 280-380bhp so my power expectations is in or around the 380bhp mark i would prefer to have something similar to the revo sps so im not running the car constantly at max power (the engine only has 17552 miles on it dont want to blow up a pretty much brand new engine)
So as regaurds to the wideband conversion any feed back is greatly appreciated...
Thanks in advance
Tsr rods
Wossner low compression pistons
660cc injectors
265lph fuel pump
4fpr
3" maf housing
Fmic
Wmi
Induction kit totally sealed green enclosed
Gt28 turbo (forget the model)
G60 lightened flywheel
Vr6 clutch
Pelloquin LSD
Vibratecnics mounts all round
Polybushed all round
Front and rear strut braces
3" downpipe
2.75" jetex stainless 100 cell sports cat
According to revo a stage 3 with these mods expects between 280-380bhp so my power expectations is in or around the 380bhp mark i would prefer to have something similar to the revo sps so im not running the car constantly at max power (the engine only has 17552 miles on it dont want to blow up a pretty much brand new engine)
So as regaurds to the wideband conversion any feed back is greatly appreciated...
Thanks in advance
