Welcome to our new sponsor Lecatona, a brand dedicated to enhancing performance for VAG group sports cars, including SEAT, Audi, Volkswagen and Škoda. Specializing in High Pressure Fuel Pump (HPFP) upgrades.
Hi
I bought a vehicle on Saturday 10th August, Toledo 2016 1.2 TSI 110 bhp, at the moment of sale I have reported to the salesman a noise at low RPM, and he reassured me that the car was fine and inspected.
I did try the car on the past days but the noise persist, it's similar to a...
Hello. i have a 2003 mk2 toledo 1.8T. i have some problems with my cruise control. it does absolutely nothing, it started switching off by its self once in a while, but is now completely dead. i tried hooking up a vcds wich showed that clutch and brake switch are working as they should, but...
after spoting the thread about the intake pipes in this tdi section ive seen people seem to do the r32 dsg mod...
but as im a tightass(lol) i plan to just fit 80mm flexible ducting as many do on mk4 golfs..
http://uk-mkivs.net/forums/p/32489/272319.aspx#272319
question is has anyone...
Hello,
Can anyone tell me where the fuel pump relay is located on an 04 tdi Toledo? I've found a small relay box above the MAF near the windscreen, but there are only 2 relays in there. Not sure if one is the correct relay to replace. The number I have on the part that has arrived is 643 but...
Just behind the clocks, to the right hand side sort of where the a pillar meets the dash.
but also sounds likes its deeper in the dash....
does anyone have any ideas, i think it may slowly drive me mad whilst i commute 1h40mins a day at 70mph!
Cheers Dale
I recently subbed my Toledo and obviously had to find a way to take the wires from the front to the boot. I did so thus.
Preparation.
1. Open passenger door
2. Remover small plastic trim covering the now exposed end of the dash board. This is held on by 3 metal clips and can be easily...
just purchased bonrath badgeless grill for my o3 toledo sport but need advice on fitting!! it looks like i have to cut off the central badged bit of the old grill to fit the new one. does anyone know if this is correct??
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.