rollers

Well I went to Oulton Park today in my 1.8T. Had a few Scoobies in the past and was worried about a front wheel drive car, well I had no need to worry it handled great;) It had front and rear Whiteline ARB's fitted the weekend and boy it handled great,also had the brakes uprated..... One...

had my cupra rooling roaded yesterday morning so here a video of it on there it made 342.3bhp and 363.7 lb/ft fairly happy with the results on that run it made 331 and some torques!!

....67.5bhp & 85.1lbft Torque Not bad really. Car only has exhaust modification and I was advised that my car is running lean and could ideally do with a bit more fuel. Any idea's why it could be running lean? Would if be worth fitting an FSE powerboost valve to increase the fuel even tho...

managed to endure a trip through plymouth today without my wheels being nicked, and took my car to ap motors for a rolling road session I wasn't expecting it to be that huge an improvement due to the age of my car, but it pipped in with a cheeky 171.3bhp and 296 lbs/ft of torque! i'm...

Big thanks to Pabs and JKM for the rolling road day, come home a happy chap... Got 165.1 bhp and 296 lb ft torque :D Chuffed to bits, comments welcome!

Just thought I'd post a few videos of my car on the rollers this morning. One video is really short because my phone memory filled up. The other is really bad quality because it's done on my :censored:[:@]Song Ericsson phone....the good quality videos are Samsung. Anyway! :lol: Sorry i...

well well the results were 247bhp at wheels,266.99 at clutch,max torque was 239..:clap: i am well pleased.Thanks to mark(Z.BOYD)for comin down and gettin some video footage on the rollers.....My code has been sucked and sent off so not too long to wait for a remap:p

Hey guys just though would get your opinions on this had car on rollers at awesome today these are figures I got on all 3 runs Run 1 188 bhp 216 Torque Run 2 183 bhp 214 Torque Run 3 185 bhp 217 Torque Temp was at 15◦c Mods I have at min are turbo back exhaust, Revo stage 1, forge...

Just wondered those who have standard turbo's who have been on Awesome GTI's rollers what power did you produce (wheel & fly). Also what modifications do you have? With the following mods; - Dynatwist Filter - Samco TIP - Forge DV - Forge FMIC - Blueflame Turbo Back Exhaust - JABBA...

Went along to a PGAC rolling road day over at SW auto's in Headcorn. There were some pretty good 106's up there and i chucked the Tdi on for a laugh. Quite chuffed, it done three runs with the all three comig out pretty much the same. Best run got 186.1Bhp @ 3813 rpm and 330lb/ft Torque @...