Anyone Running the APR maps on cruise control?

[ChrisGTL]

As above, I'm just trying to make sure i'm following the correct proceedure to activate the different stock/95/97 maps.

- Turn key to ignition position (engine not running)
- Keep 'set' pressed on cruise stalk
- Wait for the engine mgmt light to flash (1 flash for stock map / 2 flash for 95 map / 3 flash for 97 map / 4 flash for valet mode)
- Release 'set' when correct number of flashes
- Wait 5 seconds
- Turn key to off position and wait 5 seconds
- Turn key to ignition and wait 5 seconds
- Start engine


Is this correct?

Also, is there any way of knowing which map the car is using via VAGCOM? Apart from running logs and working out the MAF/MAP readings?

Just done a log for the 1st time since having the APR on;

MAF is reading 171g/s @ 5400RPM
MAP is reading 2190mbar @ 3920RPM

MAF reading looks pathetic, not sure about the MAP reading for a stage 1 LCR 225 though??

 

[JPS1]

sounds right to me mate double check here http://www.goapr.com/support/dpp_emcs_instructions.pdf or here http://www.goapr.com/support/emcs/mk4-on-off.php

not sure on the logs as i have never logged mine but the difference between stock and the 97 map is night and day! what air filter are you running?

 

[ChrisGTL]

sounds right to me mate double check here http://www.goapr.com/support/dpp_emcs_instructions.pdf or here http://www.goapr.com/support/emcs/mk4-on-off.php

not sure on the logs as i have never logged mine but the difference between stock and the 97 map is night and day! what air filter are you running?

Bloody hell, I was looking for that PDF all over the damn place, cheers for the link.

I'm running a Jetex cone, rated upto 400BHP I think.

 

[ChrisGTL]

oh, I was told to wait 5 seconds, the PDF tells me to wait 10 seconds minimum and do 2 cycles between ignition on & off.

Is the LCR a 'DirectPort Programmed' car? lol

 

[JPS1]

yeah the LCR is a direct port programmed car. i'm also running a jetex, 007p & silicon tip. Sorry i can't be any help with the logs mate, although i would be intrested in getting mine done just to see what i g/s i'm getting