highest k03s airflow anyone logged?
- Thread starter ibizacupra
- Start date
Think mine was 193g/s.
I'll dig out the logs but it was deffo in the 190's which is when i worked out the 100%+ injector duty cycle.
I'll dig out the logs but it was deffo in the 190's which is when i worked out the 100%+ injector duty cycle.
The highest i've actually logged is 189 g/s. But i know Dave and Phil can beat that 
Code:
Group A: '002
RPM Load Inj. On Time Mass Flow
TIME
STAMP /min % ms g/s
0.57 1640 9.8 1.64 3.11
1.17 1720 85.7 10.25 30.83
1.77 1880 97.7 11.07 38.58
2.37 2080 120.3 13.12 53.39
2.97 2320 145.1 16.4 68.5
3.57 2600 167.7 19.27 88.94
4.17 2920 190.2 21.73 112.5
4.78 3280 191.7 23.37 127.42
5.37 3640 191.7 22.96 144.69
5.98 3960 191.7 23.37 153.61
6.57 4240 191.7 22.96 160.31
7.17 4560 191.7 22.14 166.86
7.78 4800 188.7 21.73 171.72
8.37 5040 184.2 21.32 180.39
8.97 5280 178.2 20.5 180.86
9.57 5480 171.4 20.09 181.19
10.17 5680 167.7 19.27 181.53
10.77 5880 164.7 18.86 181.33
11.37 6000 161.7 18.86 187.61
11.97 6200 157.9 18.04 187.94
12.57 6320 154.1 17.63 186.97
13.17 6440 152.6 17.22 186.92
13.77 6600 148.9 16.81 189.53
14.37 6680 147.4 16.81 188.5
14.97 6800 145.1 16.4 187.31
15.57 6920 142.1 15.99 187.61
16.17 7000 140.6 15.99 188.89194g/s on this one also.
Does it go well bill? Because mine really shifts to be honest.
Whats the spec on it and whats your thoughts to running it on a 3" maf and 380's?
Whats the spec on it and whats your thoughts to running it on a 3" maf and 380's?
Its runs a brand new k03s (and I think still a little tight if thats possible), miltek dp/cat/system in 2.5", green open cone filter, and CC2 on it
Its goes 'ok' but not wow quick. Airflow almost flatters to deceive I think but it ran 168g/s on its stock airbox & paper filter and jumped to this 194g/s from fitting the green cone I made up for it.
boost 20-22psi peak and holds 15psi to 6k
dialed in an additional 4.5 degrees timing as it was'nt pulling any Cf's under boost.
It has an exchange maf on it, bosch and element number is correct as I was dubious.
heck of an airflow. might have to log mrsB lupo again since I changed its ramair out for an open cone green filter.
Its goes 'ok' but not wow quick. Airflow almost flatters to deceive I think but it ran 168g/s on its stock airbox & paper filter and jumped to this 194g/s from fitting the green cone I made up for it.
boost 20-22psi peak and holds 15psi to 6k
dialed in an additional 4.5 degrees timing as it was'nt pulling any Cf's under boost.
It has an exchange maf on it, bosch and element number is correct as I was dubious.
heck of an airflow. might have to log mrsB lupo again since I changed its ramair out for an open cone green filter.
Go on, blame me, I've got broad shoulders................
(Obviously, 2 bar absolute, not 2 bar of boost)
On the same basis, I have a 14" ****. It just depends where you measure it from...
Last edited:
Similar threads
