-
Hey Guest one of our sponsors Progressive Parts is running Black Friday and Cyber Monday offers - more details here
FR with twin exit exhaust
- Thread starter mikey-typer
- Start date
It's a hybrid exhaust, 3" Milltek DP, Supersprint non-res and dual pipe back box.. It's reassuringly expensive, a full Milltek comes in roughly £850 cheaper...
where did you get that done?
what about the rear bumper? did you buy it or did you cut the existing one to fit the extra pipe?
I asked at the dealers and they said they whilst the exhaust would mechanically fit, you would have to have the plastic cut yourself.
Thing with the FR is that the tailpipe is dual so the hole on the left would be too big once only a single exhaust goes into it.
C&R's in Nottingham fitted it, yes the right side was cut to match the left, made a template from the left side, reversed it carefully positioned it (measure thrice, cut once), with regard to the FR, it might be worth getting a cupra rear valence for the larger cut out...
How much did it cost in total? Can you get just the valence? Would be better that way as you could keep the old one and the old exhaust and revert back to standard if need be. I assume that you only need to get the rear exhaust sections and not a full one?
I can also confirm that Bob's exhaust sounds 'kin lovely!!!
Sounds even better with the 3"dp now
... the cat back part cost £1,150, the 3"dp cost £650, didn't need to buy the valance, just cut to fit...
http://seatepac.gedas.co.uk/model.a...ON 2006 >&category=Sport&subcategory=Exhausts
Seems the trim is about £50 and the exhausts £250 (I'm not after the fancy stuff, just the looks! ) Might see if I have any pennies left over in the summer! How much did the garage charge for fitting?
Seems the trim is about £50 and the exhausts £250 (I'm not after the fancy stuff, just the looks!
) Might see if I have any pennies left over in the summer! How much did the garage charge for fitting?
It's the one that you can buy for the aero kit, it came off a petrol one and i had my back box cut off and the new one welded on to my TDI cost me £50 to have the work done
It's the one that you can buy for the aero kit, it came off a petrol one and i had my back box cut off and the new one welded on to my TDI cost me £50 to have the work done
On the SEAT website the TDI and FSI are different exhausts. Are they pretty much the same?
Also, do you need to take the bumper off to get the black panel out?
The back box is the same so cut it off the petrol exhaust and just used that as for the rest of the exhaust it is a slightly different shape near to the front, the black panel just pulls out but it's difficult to do but once you get one side to move it's easy then.
Similar threads
