What do you guys think of my badges?

[skahigh]

Comments please guys?

Front:

Rear:

 

[olaf]

Like the Cupra, not keen on the R!

And wheres your Fabia wiper?!

 

[skahigh]

haha, gotta get that done as soon as i can be arsed to ring white dove and order the parts!

 

[WaveyDaveyGravy]

Like the Cupra, not keen on the R!

And wheres your Fabia wiper?!

Ditto on all points

 

[skahigh]

or how about this:

 

[Matt85]

Like the Cupra, not keen on the R!

And wheres your Fabia wiper?!

Ditto'd again! (although i havn't got round to my fabia wiper yet either!)

 

[Funkyfin2000]

both i think look awful!

Sorry just my opinion!

 

[BCM]

fronts nice, bit high tho, back has got to go! NOW!

 

[dan__smith]

Personally not a fan of either, but hey...If you like them, then keep them

Get the fabia wiper

 

[Snoopcousins]

Dont like the rear, would be better IMO if the R was in the bottom corner of boot. Front is ok but again I think it looks better if down a few lats on the grill. But thats just my view, doesnt change the fact its a great car!

Heres a couple of mine....

 

[Avant4me]

Just out of interest how did you attach the badge to the grill. I think it looks well smart.

 

[dan__smith]

A bit of glue along the grille and then stick the badge on I think...

 

[Empi5]

debadge the lot, especially the rear.

 

[BCM]

of you look closely there photchoped badges, he's not done them yet think he's just thinkin what if!

 

[Snoopcousins]

Epoxy glue is the best, the one where you mix the 2 parts of it together.
It takes a good 12 hours to harden (you will need to hold it in shape with sellotape overnight) but it aint ever coming off after that!

 

[Funkyfin2000]

i just used ordinary glue on mine, extra strength for my cupra badge on my ibiza...

 

[Mike Green]

Personally I like the front but not too keen on the back. I prefer as standard on the back but yeah like the front.

 

[skahigh]

of you look closely there photchoped badges, he's not done them yet think he's just thinkin what if!

spot on good old ms paint!

Im planning on putting a red cupra badge on the front slats and doing something with the rear (not sure what). I would like to replace the 'S' badge so that the boot opener is just a smooth black piece like the rest of the bodywork, not sure how im going to manage that.

 

[olaf]

You would need to install a remote release and then get some bodywork done.

 

[skahigh]

my idea for doing the front was a piece of black polyurethane type stuff slotted between he slats and screwed/glued in place with the cupra badge stuck to the front of that.